Any Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority
to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Specific Absorption Rate (SAR) information
SAR tests are conducted using standard operating positions
accepted by the FCC with the phone transmitting at its highest
certified power
level in all tested frequency bands, although the SAR is determined
at the highest certified power level, the actual SAR level of the
phone while operating can be well below the maximum value, in
general, the closer you are to a wireless base station antenna, the
lower the power output.Before a new model phone is a available
for sale to the public, it must be tested and certified to the FCC that
it does not exceed the exposure limit established by the FCC, Tests
for each phone are performed in positions and locations (e.g. at the
ear and worn on the body)as required by the FCC.For body worn
operation, this model phone has been tested and meets the FCC RF
exposure guidelines when used with an accessory designated for this
product or when used with an accessory that Contains no metal and
that positions the handset a minimum of 1.0 cm from the body.
Non-compliance with the above restrictions may result in
violation of RF exposure guidelines.