PNP-35 CABLE INSTRUCTIONS
y
PNP-35 CABLE
1. Connect a Phono cable from the AMP
jack of the ARB to the Amplifier's Relay.
CAUTION:
DO NOT use the ARB-704 with amplifier
relays that are not pulled
activate!
If the amplifier has a standard RCA
phono plug it will always be safe to use
with this unit
The relay or amplifier control system
MUST be the type that is pulled to
ground to activate! Nearly all commercial
amplifiers manufactured after the mid
1960's is safe to use with this unit. The
ARB-704 connects between the radio and
amplifier, preventing damage to the radio
from amplifier keying voltages.
The ARB-704 works with all standard
manufactured amplifiers including those
with positive, negative, and AC relay
lines. This includes, but is not limited to,
Ameritron, B&W, Collins, Command,
Dentron, Heathkit, Kenwood, and Yaesu
amplifiers.
The safest way to tell if the ARB-704 will
work is to look at the relay connectio n on
the amplifier panel. If the connection is
through a phono (RCA) jack, or has one
terminal directly grounded to the chassis,
this unit will almost certainly work.
2. If using ALC, connect a Phono cable
from the ALC of the ARB jack to the
Amplifier's ALC.
ground to
to
3. Connect the 5-pin end of the "plug and
play cable" into the multi-port of the
Then, connect the mini stereo end into
the ACC jack o f t he Yaesu FT-100.
4. Connect power to the ARB's power jack.
Red is positive and Black is ground or
negative.
The ARB's radio jack is not used for this
application.
When the transceiver is placed into
transmit, the light on the ARB will light
and the amplifier will go into transmit
This Cable is to interface the
Yaesu FT-100 series with the
ARB-704.
116 Willow Road
Starkville, MS 39762
USA 662-323-8211
If you have any problem with this unit, you
ma
contact Ameritron Technical Service at:
Ameritron
116 Willow Road
Starkville, MS 39759
(662) 323-821 1
You will be best helped if you have your unit,
and all information on your station handy so
you can answer any questions the technicians
may have.
For rapid responses, please telephone
Ameritron between 8:00 a.m. and 4:30 p.m.
CST Mo nd a y t hr o ug h F rid a y .
Written correspondence may take over 45 days
to process and return. If you need a prompt
reply, call us. Do not write. Most problems ca n
be handled over the telephone without delay.
Loading...