Ameritron PNP-13D AME-PNP-

PNP-13D CABLE INSTRUCTIONS

y

PNP-13D CABLE

Connect a Phono cable from the AMP jack of
the ARB to the Amplifier's Relay.

CAUTION:

DO NOT use the ARB-704 with amplifier relays
that are not pulled to ground to a ctivate!

If the amplifier has a standard RCA phono plug
it will always be safe to use with this unit

The relay or amplifier control system MUST be
the type that is pulled to ground to activate!
Nearly all commercial amplifiers manufactured
after the mid 1960's is safe to use with this
unit. The ARB-704 connects between the radio
and amplifier, preventing damage to the radio
from amplifier keying voltages.

The ARB-704 works with all standard
manufactured amplifiers including those with
positive, negative, and AC relay lines. This
includes, but is not limited to, Ame ritron, B&W,
Collins, Command, Dentron, Heathkit,
Kenwood, and Yaesu amplifiers.

Connect the 5-pin end of the "plug and play
cable" in to the multi-port of the ARB.

Then, connect the 13-pin end into the ACC jack
of the Icom 706.

NOTE:

The ARB's power and radio jack is not used for
this appli cat io n

When the transceiver is placed into transmit,
the light on the ARB will light and the amplifier
will go into transmit mode.

If you have any problem with this unit, you
ma

You will be best helped if you have your unit,
and all information on your station handy so
you can answer any questions the technicians

DO NOT connect power to the ARB's

power jack.

contact Ameritron Technical Service at:

Ameritron
116 Willow Road

Starkville, MS 39759
(662) 323-821 1

This Cable is to inter face the Icom-

706 series to the ARB-704, and comes

supplied with the ARB-704I2

116 Willow Road

Starkville, MS 39762

USA 662-323-8211

The safest way to tell if the ARB-704 will work
is to look at the relay connection on the
amplifier panel. If the connection is through a
phono (RCA) jack, or has one terminal directly
grounded to the chassis, this unit will almost
certainly work.

If using ALC, connect a Phono cable from the
ALC of the ARB jack to the Amplifier's ALC.

For rapid responses, please telephone
Ameritron between 8:00 a.m. and 4:30 p.m.
CST Mo nd a y t hr o ug h F rid a y .

Written correspondence may take over 45 days
to process and return. If you need a prompt
reply, call us. Do not write. Most problems can
be handled over the telephone without delay.