American Standard M968656 User Manual

DIVERTER TRIM KIT

Installation

Instructions

M 9 6 8 6 5 6

T555430

TOWNSQUARE

Thank you for selecting American-Standard...the
benchmark of fine quality for over 100 years.

To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.

Certified to comply with ANSI A112.18.1

ROUGHING-IN DIMENSIONS

Recommended Tools

Flat Blade Screwdriver

Phillips Screwdriver

Remove as much surface dirt and film using clear
water and soft cotton cloth (as described above).

Use any of the following to remove tough surface
film and build-up:
Mild liquid detergents
Clear ammonia free liquid glass cleaners
Non-acidic, non-abrasive gentle liquid or fully
dissolved powder cleansers mixed according to
manufacturers directions.
Non-abrasive liquid polishers

Once clean, rinse faucet again with clear water to
thoroughly remove cleaner or polish and blot dry with
a soft cotton cloth.

To keep your new faucet looking new, please follow
these simple care instructions:

DO: Simply rinse the faucet clean with clear water.
Dry the faucet with a soft cotton cloth.

DO NOT:
Do not use any abrasive cleaners, cloths, or
paper towels.
Do not use any cleaning agents containing
acids, polish abrasives, or harsh cleaners or
soaps.

Regular and routine cleaning will reduce the need for
heavy cleaning and polishing. If heavy cleaning is
required, the following procedures are recommended:

CARE INSTRUCTIONS:

Failure to follow these care instructions may
damage the Faucet's finish.

FINISHED

WALL

FINISHED

WALL

41mm MIN.

(1-5/8)

66mm MAX.

(2-5/8)

71mm

(2-3/4)

57mm HOLE SIZE
(2-1/4)

75mm

(2-7/8)

M 9 6 8 6 5 6 M 9 6 8 6 5 6

OPERATING THE VALVE

OFF

1

Place ESCUTCHEON (1) onto ESCUTCHEON HOLDER (2).

Align ESCUTCHEON (1). Thread ESCUTCHEON HOLDER (2) onto DIRVERTER VALVE (3).

Tighten until ESCUTCHEON (1) is snug against fiished wall.

TRIM INSTALLATION

1

2

3

2

HANDLE INSTALLATION

Push HANDLE ADAPTER (1) onto VALVE STEM (2).

Turn VALVE STEM (2) to off position.

Push HANDLE ASSEMBLY (3) onto HANDLE ADAPTER (1).

In stall HANDLE SCREW (4) and tighten.

Push INDEX BUTTON (5) into HANDLE ASSEMBLY (3).

3

Turn water supply on and test installed fitting.

Rotate handle to all diverter positions to check operation of valve.

Check for leaks.

2

1

3

4

5