American Standard 9210.224.329 User Manual

ASSEMBLY & INSTALLATION INSTRUCTIONS

- 1 -

Recommended Tools & Materials

Roughing-in Dimensions

Product names listed herein are trademarks of American Standard Inc.
© American Standard Inc. 2008

Hacksaw

Channel Locks

Adjustable Wrench

Tubing Cutter

Basin Wrench

Putty Knife

Tape
Measure

Plumbers’ Putty or
Caulking

Regular Screwdriver

Phillips Screwdriver

Drill

Level

Pipe Wrench

Generations 24" Washstand

9210.224.329

770 0 0 2-1 0 0 770 0 0 2-1 0 0 770 0 0 2-1 0 0 770 0 0 2-1 0 0

Thank you for selecting our products...products which have been the benchmarks of fine quality for over 100 years.
To help insure that the installation process will proceed smoothly, please read these instructions carefully before you begin.
Also, review the recommended tools and materials list; carefully unpack and examine your new plumbing fixture.

To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading.
Also avoid extreme changes in temperature by arranging furniture away from radiators, heat and air vents,
and air conditioning units. Avoid placing furniture directly under windows.

22-1/2"

(570mm)

18"

(457mm)

33"

(838mm)

14-1/8"

(359mm)

16"

(406mm)

18"

(457mm)

TOWNSEND

SINK

SUPPLIES AS

REQUIRED

FINISHED

FLOOR

FINISHED

FLOOR

FINISHED

WALL

VANITY TOP

No top required for
Townsend Vanity Top (sink)

0555.104 Townsend Vanity Top (4" centers)

0555.108 Townsend Vanity Top (8" centers)

7005.201 Copeland Center Spread

7005.801 Copeland Wide Spread

RECOMMENDED SINKS RECOMMENDED FAUCETS

1-1/4" O.D.

WASTE

8"

(203mm)

- 2 -

WASHSTAND INSTALLATION

Unpack unit carefully, taking care that bottom shelf does not drop and damage front legs (see Figure 2).

Provide suitable reinforcement for anchoring the washstand to the wall. Centerline of reinforcement should be 27-3/4"
up from the floor (see Figure 1).

Rough in supply lines and waste per rough-in dimensions.

The molding needs to be notched to seat the washstand flush against the wall.

Move the washstand into place and level with the adjustable glides on the bottom of the feet.
The glides can be adjusted outward up to 1" but it is recommended not to exceed 1/2" if possible.

Drill at least two 3/8" O.D. anchoring holes through the centerline of the rear stringer of the vessel stand, located 3/4"
down from the top of the table (see Figure 2).

Anchor the washstand to the wall through at least 2 of the anchoring holes in the rear of the washstand (see Figure 2).

Continue with installation appropriate for top and sink options chosen.

C/L of 2 x 6
Reinforcement

Finished
Floor

27-3/4"

(705mm)

FIGURE 1

ADJUSTABLE

LEVELLERS

(under each foot)

FINISHED

FLOOR

FINISHED

WALL

REAR STRINGER

WITH ANCHORING

HOLES TO SECURE

VANITY TO WALL

FIGURE 2

ANCHORING
HOLES
IN REAR
STRINGER
[NOT SHOWN]

33"

(838mm)

2-1/2"

(64mm)

4"

(102mm)