American Standard 9210.030.329 User Manual

ASSEMBLY & INSTALLATION INSTRUCTIONS

Generations 30" Vanity

9210.030.329

VANITY TOP

9210.130.251 Laminated 31" Marble Top

RECOMMENDED SINKS RECOMMENDED FAUCETS

0615.000 Rattan Undermount Sink

7005.201 Copeland

Center Set Faucet
No additional top required for Newbern
Vanity Top

7820.400.020 Newbern Vanity Top

- 4" Centers

7820.800.020 Newbern Vanity Top

7005.801 Copeland

Widespread Faucet

- 8" Centers

Thank you for selecting our products...products which have been the benchmarks of fine quality for over 100 years. To
help insure that the installation process will proceed smoothly, please read these instructions carefully before you begin.
Also, review the recommended tools and materials list; carefully unpack and examine your new plumbing fixture.

To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading. Also avoid
extreme changes in temperature by arranging furniture away from radiators, heat and air vents, and air conditioning
units. Avoid placing furniture directly under windows.

Recommended Tools & Materials

Adjustable Wrench

Basin Wrench

Tubing Cutter

Channel Locks

Plumbers’ Putty or
Caulking

Hacksaw

Tape
Measure

Pipe Wrench

Putty Knife

Drill

Phillips Screwdriver

Regular Screwdriver

Level

Roughing-in
Dimensions

33-1/2"

(851mm)

27-1/4"

(692mm)

4-3/4"

(120mm)

Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2008

30"

(762mm)

8"

(203mm)

1-1/4" (32mm)

O.D. WASTE

FINISHED

FLOOR

- 1 -

NEWBERN SINK

OPTIONAL:

LAMINATED MARBLE
TOP WITH RATTAN
UNDERMOUNT SINK

SUPPLIES AS

REQUIRED

20"

(508mm)

22"

(559mm)

21-1/2"

(546mm)

FINISHED

FLOOR

FINISHED

WALL

770011-100

VANITY INSTALLATION

Unpack unit carefully, taking care that bottom shelf does not drop and damage front legs (see Figure 2).

Provide suitable reinforcement for anchoring the vanity to the wall. Centerline of reinforcement should be 31" up
from the floor (see Figure 1).

Rough in supply lines and waste per rough-in dimensions.

The molding needs to be notched to seat the vanity flush against the wall.

Move the vanity into place and level with the adjustable glides on the bottom of the feet.
The glides can be adjusted outward up to 1" but it is recommended not to exceed 1/2" if possible.

Drill at least two 3/8" O.D. anchoring holes through the centerline of the rear stringer of the vessel stand, located 1"
down from the top of the table (see Figure 2).

Anchor the vanity to the wall through at least 2 of the anchoring holes in the rear of the vanity (see Figure 2).

Continue with installation appropriate for top and sink options chosen.

FIGURE 1

C/L of 2 x 6
Reinforcement

FIGURE 2

33-1/2"

(850mm)

31"

(787mm)

Finished
Floor

21-1/2"

(546mm)

REAR STRINGER WITH

ANCHORING HOLES TO

SECURE VANITY TO WALL

3"

(76mm)

ANCHORING HOLES

IN REAR STRINGER

[NOT SHOWN]

ADJUSTABLE

LEVELLERS

(under each

foot)

- 2 -

770011-100