American Standard 9205.030.339 User Manual

ASSEMBLY & INSTALLATION
INSTRUCTIONS

Studio 30" Vanity

9205.030.339

Thank you for selecting our products...products which have been the benchmarks of fine
quality for over 100 years. To help insure that the installation process will proceed smoothly,
please read these instructions carefully before you begin. Also, review the recommended
tools and materials list; carefully unpack and examine your new plumbing fixture.

To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading.
Also avoid extreme changes in temperature by arranging furniture away from radiators, heat and air vents,
and air conditioning units. Avoid placing furniture directly under windows.

VANITY TOP

RECOMMENDED SINKS RECOMMENDED FAUCETS

9205.130 Laminated 30" Marble Top 0614.000 Studio Undercounter Sink

Recommended Tools & Materials

Adjustable Wrench

Basin Wrench

Tubing Cutter

Channel Locks

Plumbers’ Putty
or Caulking

Hacksaw

Tape
Measure

Roughing-in
Dimensions

30"

(762mm)

LAMINATED

MARBLE TOP

UNDERMOUNT SINK

Pipe Wrench

Putty Knife

2506.201 Moments Faucet

2064.101P Deck Plate

Drill

Phillips Screwdriver

Regular Screwdriver

22"

7-1/2"

(191mm)

(559mm)

Level

35-1/4"

(895mm)

6-1/4"

(159mm)

Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2008

8"

(203mm)

1-1/4" (32mm)

O.D. WASTE

FINISHED

FLOOR

- 1 -

22"

(559mm)

24"

(610mm)

FINISHED

FLOOR

FINISHED

WALL

770013-100

VANITY INSTALLATION

Unpack unit carefully, taking care that bottom shelf does not drop and damage front legs (see Figure 2).

Provide suitable reinforcement for anchoring the vanity to the wall. Centerline of reinforcement should be 33-1/2" up
from the floor (see Figure 1).

Rough in supply lines and waste per rough-in dimensions.

The molding needs to be notched to seat the vanity flush against the wall.

Move the vanity into place and level with the adjustable glides on the bottom of the feet.

The glides can be adjusted outward up to 1" but it is recommended not to exceed 1/2" if possible.

Drill at least two 3/8" O.D. anchoring holes through the centerline of the rear stringer of the vessel stand, located 3/4"
down from the top of the table (see Figure 2).

Anchor the vanity to the wall through at least 2 of the anchoring holes in the rear of the vanity (see Figure 2).

Continue with installation appropriate for top and sink options chosen.

FIGURE 1

FIGURE 2

35-1/4"

(895mm)

C/L of 2 x 6
Reinforcement

(851mm)

Finished
Floor

(559mm)

33-1/2"

22"

REAR STRINGER WITH
ANCHORING HOLES TO
SECURE VANITY TO WALL

4-1/4"

(108mm)

ANCHORING HOLES

IN REAR STRINGER

[NOT SHOWN]

ADJUSTABLE

LEVELLERS

(under each foot)

FINISHED

WALL

After top is replaced, connect the trap to the drain assembly hand tight to check
alignment. It may be necessary to cut off part of the tailpiece (area "A") or part
horizontal leg of the trap (area "B").

Connect hot and cold supply lines to the shut off valves. Tighten trap joints for
watertight assembly.

- 2 -

B

A

770013-100