American Standard 9205.024.339 User Manual

ASSEMBLY & INSTALLATION INSTRUCTIONS

Studio 22" RTU Vanity

9205.024.339

VANITY TOP

9205.124 Laminated 22" Marble Top

0978.000.321 Frosted Glass Round Vessel

RECOMMENDED SINKS RECOMMENDED FAUCETS

0978.000.200 Clear Glass Round Vessel

No top required for Rectangular

0960.000.020 China Round Vessel

0621.001.020 Rectangular Vessel Sink

2506.101 Moments Faucet

Vessel Sink

Thank you for selecting our products...products which have been the benchmarks of fine quality for over 100 years.
To help insure that the installation process will proceed smoothly, please read these instructions carefully before you begin.
Also, review the recommended tools and materials list; carefully unpack and examine your new plumbing fixture.

To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading. Also avoid
extreme changes in temperature by arranging furniture away from radiators, heat and air vents, and air conditioning units.
Avoid placing furniture directly under windows.

Recommended Tools & Materials

Adjustable Wrench

Basin Wrench

Tubing Cutter

Channel Locks

Plumbers’ Putty or
Caulking

Hacksaw

Tape
Measure

Pipe Wrench

Putty Knife

Drill

Phillips Screwdriver

Regular Screwdriver

Level

Roughing-in
Dimensions

Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2008

SQUARE

CHINA

30-1/4"

(768mm)

SINK

6-3/8"

(162mm)

21-3/4"

(552mm)

8"

(203mm)

1-1/4"(32mm)
O.D. WASTE

FINISHED

FLOOR

- 1 -

OPTIONAL:

LAMINATED MARBLE
TOP WITH VESSEL

18"

(456mm)

16"

(406mm)

18-3/16"

(462mm)

FINISHED

FLOOR

REAR STRINGER
WITH ANCHORING
HOLES TO SECURE
VANITY TO WALL

3-7/8"

(98mm)

FINISHED

WALL

770015-100

RTU (Ready to Unfold) VANITY INSTALLATION

Unpack unit carefully, taking care that bottom shelf does not drop and damage front legs (see Figure 2).

Provide suitable reinforcement for anchoring the vanity to the wall. Centerline of reinforcement should be 28-1/2" up
from the floor (see Figure 1).

Rough in supply lines and waste per rough-in dimensions.

Unfold the vanity and position in desired location. The molding needs to be notched to seat the vanity flush against
the wall.

Move the vanity into place and level with the adjustable glides on the bottom of the feet.
The glides can be adjusted outward up to 1" but it is recommended not to exceed 1/2" if possible.

Drill at least two 3/8" O.D. anchoring holes through the centerline of the rear stringer of the vessel stand, located 3/4"
down from the top of the table (see Figure 2).

Anchor the vanity to the wall through at least 2 of the anchoring holes in the rear of the vanity (see Figure 2).

Continue with installation appropriate for top and sink options chosen.

FIGURE 1

C/L of 2 x 6
Reinforcement

FIGURE 2

28-1/2"

(724mm)

Finished
Floor

ANCHORING

HOLES IN REAR

STRINGER

(NOT SHOWN)

- 2 -

ADJUSTABLE

LEVELLERS

(under each foot)

770015-100