American Standard 7293.172 Installation Manual
Installation
Instructions
7293.172
Heritage Wall Mount Sink Faucet,
with Gooseneck Spout and Screwdriver
Stops in Shanks
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
RECOMMENDED TOOLS
Certified to comply with ANSI A112.18.1M
M965048 REV.1.6
Channel Locks
ROUGHING-IN DIMENSIONS
215mm
(8-1/2")
1/2" NPT
(FEMALE)
60mm Dia.
(2-3/8")
120mm
(4-3/4")
168mm
(6-5/8")
FINISHED WALL
Adjustable Wrench
265mm
(10-7/16")
Plumbers' Putty or Caulking
407mm
(16")
203mm (8")
Phillips Screwdriver
25.4mm (1")
OFF SET
ROUGH-IN
1
Prepare water supply lines per "Roughing-in
Dimensions". Install 1/2" NPT. SUPPLY NIPPLES
FINISHED
1/2" NPT.
FEMALE
THREADS
1/2" NPT.
SUPPLY NIPPLE
WALL
1-1/4" DIA.
OPENING
1/2" to 1"
FINISH INSTALLATION
2
Apply thread sealant or teflon tape to SUPPLY NIPPLES (1).
Thread ESCUTCHEONS (2) fully onto INLET SHANKS (3).
Thread INLET SHANKS (3) onto SUPPLY NIPPLES (1). Distance
between INLET SHANK (3) outlets must be 8" to match the VALVE.
Insert RUBBER WASHERS (4) into COUPLING NUTS (5).
Attach VALVE (6) to INLET SHANKS (3). Tighten both COUPLING
NUTS (5) firmly.
1
2
3
8"
5
TEST FAUCET
3
Remove AERATOR (1).
Turn HANDLES TO OFF POSITION.
Slowly turn water supplies on and check all connections for leaks.
Operate HANDLES to flush water lines thoroughly.
Turn HANDLES to OFF position and replace AERATOR (1).
Thread ESCUTCHEONS against finished wall.
SERVICE
4
To change direction of handle rotation, proceed as follows:
Turn HANDLE to OFF position.
Remove HANDLE SCREW and HANDLE.
Remove SPRING CLIP (1).
Lift STOP WASHER (2), turn 90° and replace.
Replace SPRING CLIP (1).
Replace HANDLE and HANDLE SCREW.
4
6
OFF
1
90˚
ON
90°
2
2
AERATOR may accumulate dirt causing distorted and reduced water flow.
Remove AERATOR and rinse clean.
If spout drips, operate handles several times from OFF to ON position.
Do not force - handles turn only 90°.
CARE INSTRUCTIONS:
5
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
1
M965048 REV.1.6
Loading...