American Standard 7185.011, 7185.813 User Manual

SILHOUETTE™ 18" ISLAND SINK

• Americast® brand engineered material

• Single bowl design

• Titanium enamel - heat resistant up to 1000°

• Acid-resisting glossy porcelain nish

• Tile edge installation

• Silicone sealant supplied

• Available in 1 or 3 faucet hole conguration

• Customized hole punchings available (See page G56)

Tile Edge:

❏ 7185.011 Center hole only ❏ 7185.813 3 hole

SILHOUETTE™ 18"

ISLAND SINK

AMERICAST

Nominal Dimensions:

457 x 447 x 216mm (18" x 18" x 8-1/2")

Bowl sizes:

375mm (14-3/4") wide 375mm (14-3/4") front to back 203mm (8") deep

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.4M for Americast Plumbing Fixtures

• ASTM E162 for Flammability

• NFPA 258 for Smoke Density

To Be Specied:

❏ Color: ❏ Faucet*: ❏ Faucet Finish: ❏ Basket Strainer: 4331.013 ❏ Soap Dispenser: 4503.115, Color: ❏ Trap:

Shown with 7100.271H Heritage Bar Faucet with Wrist Blade Handle (not included)

SEE REVERSE SIDE FOR ROUGHING-IN DIMENSIONS

Optional Accessories:

❏ Small Wood Cutting Board: 9000.185 ❏ Colander for Cutting Board: 8102.100, Color:

* See faucet section for available models

G39

Revised 2/08

7185.813

C/L

FIN IS HE D WALL OR SP LA SH BACK

*C UT OU T NOTE

SEA LI NG C OMPOU ND

FIN IS HE D FLOOR

TIL ED

COU NT ER TO P

(BY O TH ER S)

1-1 /2 " O .D . TAILP IE CE

36" (9 14 mm )

SUG GE ST ED

3/8 " (10 mm )

5-3 /4 "

(14 6m m)

8-5 /8 "

(21 9m m)

18"

(45 7m m)

18"

(45 7m m)

(22 9m m)

3-1 /2 "

(89 mm )

DIA .

7-3 /8 "

(18 7m m)

1-1 /2 " ( 38 mm) DIA . HO LE S TYP.

2" ( 51 mm )

OPT IO NA L

2" (51 mm )

2" ( 51 mm )

4-5 /8 " (11 7m m)

2-5 /8 "

(67 mm )

SHOWN WITH 2560.221 FITTING

SILHOUETTE™ 18"

ISLAND SINK

AMERICAST

NOTES:

COUNTERTOP CUTOUT 425mm x 425mm WITH 25mm RADIUS

(16-3/4 X 16-3/4 WITH 1" RADIUS) AT CORNERS.

FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.

PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL AND COUNTERTOP SUPPORTS.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ASME Standard A112.19.4 These measurements are subject to c hange or cancellation. No responsibility is assumed for use of superseded or voided leaet.

G40

Revised 2/08