American Standard 7179.803, 7179.804, 7179.001, 7179.805 User Manual

SILHOUETTE™ 33" DUAL LEVEL KITCHEN SINK

• Americast® brand engineered material

• Dual level double bowl design

• Titanium enamel - heat resistant up to 1000°

• Acid-resisting glossy porcelain nish

• Top mount or undercounter installation

• Silicone sealant supplied

• Available in 1, 3, 4, or 5 faucet hole conguration

• Customized hole punchings available (see page G56)

Top Mount/Undercounter:

❏ 7179.001 Center hole only ❏ 7179.803 3 hole ❏ 7179.804 4 hole ❏ 7179.805 5 hole

SILHOUETTE™ 33"

DUAL LEVEL SINK

Top Mount Installation

(faucet not included)

AMERICAST

Undercounter Installation Order:

❏ 791326-100 Mounting Kit (consists of

cut-out templates and mounting clips)

Nominal Dimensions:

838 x 559 x 241mm (33" x 22" x 9-1/2")

Bowl sizes:

Right Hand: 191mm (7-1/2") wide 413mm (16-1/4") front to back 178mm (7") deep Left Hand: 527mm (20-3/4") wide 476mm (18-3/4") front to back 229mm (9") deep

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.4M for Americast Plumbing Fixtures

• ASTM E162 for Flammability

• NFPA 258 for Smoke Density

SEE REVERSE SIDE FOR ROUGHING-IN DIMENSIONS

Undercounter Mount Installation

(faucet not included)

To Be Specied:

❏ Color: ❏ Faucet*: ❏ Faucet Finish: ❏ Basket Strainer: 4331.013 ❏ Soap Dispenser: 4503.115, (specify color): ❏ Traps:

Optional Accessories:

❏ Large Wood Cutting Board: 9000.250 ❏ Small Wood Cutting Board: 9000.185 ❏ Colander for Cutting Board: 8102.100, Color: ❏ Large Colander: 8103.100, Color: ❏ Web Cover: 8106.100, Color: ❏ Bottom Sink Rack (Left): 7407.100, Color:

* See faucet section for available models

G23

Revised 2/08

7179.803/804/805 Top Mount

3-1/ 2"

(89m m)

DIA.

2-1/ 8" (54m m)

2" (5 1mm)

OPTI ONAL

FINI SHED WALL OR S PLASH BACK

7-7/ 8"

(200 mm)

8-1/ 8"

(206 mm)

1-1/ 2" (38 mm) DIA. HOLE S TYP.

C/L

5/8" (16mm )

9-3/ 4"

(248 mm)

11-1 /8"

(282 mm)

16-1 /2"

(419 mm)

33"

(838 mm)

9-1/ 8"

(232 mm)

SEAL ING COMP OUND

FINI SHED FLOOR

COUN TERTO P

(BY OTHER S)

22"

(559 mm)

*CU TOUT NOTE

7179 .804 4 HO LE

1-1/ 2" (38 mm)

RAD. TYP.

1-1/ 2" O.D . TAIL PIECE

(152 mm)

1/2"

(13m m)

7179 .805

5 HO LE

4" (1 02mm)

5-3/ 4"

(146 mm)

36" ( 914mm )

SUGG ESTED

5-3/ 4"

(146 mm)

FINI SHED WALL OR S PLASH BACK

C/L

SEAL ING COMP OUND

FINI SHED FLOOR

COUN TERTO P

(BY OTHER S)

CUTO UT

N OTE

7179 .804 4 HO LE

1-1/2" O.D. TAILPIECE

6-1/ 2"

(165 mm)

7179 .805

5 HO LE

MOUN TING CLIP (SEE DETA IL)

DETAI L OF MOUNTI NG CL IP

(KIT No.79 1004-1 00)

BRASS

INSER T

1/2

(13mm )

MIN.

REFER TO I NSTRUC TIONS

PROVI DED W ITH KI T FOR

ADDIT IONAL INFOR MATIO N

CLIP MACH. SCREW

SINK

5-3/ 4"

(146 mm)

36" ( 914mm )

SUGG ESTED

9-3/ 4"

(248 mm)

11-1 /8"

(282 mm)

16-1 /2"

(419 mm)

33"

(838 mm)

22"

(559 mm)

5-3/ 4"

(146 mm)

9-1/ 2"

(241 mm)

3-1/ 2"

(89m m)

DIA.

1-1/ 2" (38 mm)

RAD. TYP.

2-1/ 8" (54m m)

2" (5 1mm)

OPTI ONAL

7-7/ 8"

(200 mm)

8-1/ 8"

(206 mm)

1-1/ 2" (38 mm) DIA. HOLE S TYP.

5/8" (16mm )

4" (1 02mm)

SILHOUETTE™ 33"

DUAL LEVEL SINK

AMERICAST

NOTES:

TOP MOUNT: COUNTERTOP CUTOUT 806 x 527mm WITH 25mm

RADIUS (31-3/4 X 20 -3/4 WITH 1" RAD.) AT CORNERS.

FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.

PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL AND COUNTERTOP SUPPORTS.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ASME Standard A112.19.4 These measurements are subject to c hange or cancellation. No responsibility is assumed for use of superseded or voided leaet.

NOTES:

TEMPLATE PROVIDED WITH MOUNTING KIT 791326-100 FOR

EXPOSED FAUCET DECK OR UNDERCOUNTER FAUCET DECK COUNTERTOP CUTOUT VARIATIONS.

FITTINGS AND UNDERCOUNTER MOUNTING KIT NOT INCLUDED AND MUST BE ORDERED SEPARATELY.

PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL AND COUNTERTOP SUPPORTS.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ASME Standard A112.19.4 These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaet.

Undercounter Mount

G24

Revised 2/08