American Standard 7018.018, 7018.024, 7018.190, 7018.210, 7018.230 Installation Manual
INSTALLATION
INSTRUCTIONS
7018.018 Series
EDGEMERE
™
18" TOWEL BAR
24" TOWEL BAR
TOWEL RING
ROBE HOOK
TOILET PAPER HOLDER
WITH PIVOTING BAR
Thank you for selecting American Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly-please
read these instructions carefully before you begin.
RECOMMENDED TOOLS
7018.024 Series
7018.190 Series
7018.210 Series
7018.230 Series
Certied to comply with ANSI A112.18.1M
10'
Level
Tape Measure
1
INSTALLATION OF MOUNTING BRACKETS FOR ALL WALL MOUNTED ACCESSORIES
• The WALL MOUNTED ACCESSORIES work best if secured to a wall stud or cross brace within the wall, using the SCREWS
(2) supplied.
• If the ACCESSORY is to be installed on a tile or plaster wall, the ANCHORS (3) and SCREWS (2) should be used.
• Determine desired height and location (optional) and mark a center line. Make sure the centerline is level. Using the
MOUNTING BRACKET (1) as a template, mark the two spots for the mounting holes. If MOUNTING BRACKET (1) is secured
to a stud or cross brace. drill small pilot holes for SCREWS (2).
• For installations on tiled walls or drywall, use TILE ANCHORS (3) and SCREWS (2) for securing MOUNTING BRACKET (1) to
wall. Drill two 1/4" diameter holes a minimum of 1-1/4" deep. Insert the two TILE ANCHORS (3) ush with face of nished wall.
Place MOUNTING BRACKET (1) over TILE ANCHORS (3) and insert SCREWS (2) provided with a at blade screwdriver.
See illustration below.
• Secure MOUNTING BRACKET (1)
to wall with SCREWS (2).
LEVEL
DRILL PILOT HOLE FOR
WOOD SCREW (2) OR
1/4" DIA. HOLE FOR
3
ANCHOR (3)
Flat Head Screwdriver
Phillips Screwdriver
2
Electric Drill
1
3
1
2
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2017
C
L
3/4" (19 mm)
- 1 -
3/8" (9 mm)
M965808 (10/17)
2
TOWEL RING and ROBE HOOK INSTALLATION
• Refer to Step 1 for installation of MOUNTING BRACKETS (2). Align accessory and place ACCESSORY ESCUTCHEON (1)
onto MOUNTING BRACKET (2) Secure accessory with SET SCREW (3).
3
INSTALL TOILET PAPER HOLDER
1
2
FINISHED WALL
2
1
3
3
• Refer to Step 1 for installation of MOUNTING BRACKETS (1). NOTE: The center line distance between the two
MOUNTING BRACKETS is 7-1/2" (190 mm). Make sure the two MOUNTING BRACKETS (1) are level.
• Install the ACCESSORY ESCUTCHEONS (2) on the MOUNTING BRACKETS (1). Secure ACCESSORY
ESCUTCHEONS (2) with SET SCREW (3).
FINISHED WALL
7-1/2" (190 mm)
C
L
1
LEVEL
2
1
2
3
3
3
- 2 -
M965808 (10/17)
Loading...