American Standard 5032.026, 5032.010 User Manual

HERITAGE™ BIDET

222 mm

(8- 3/4)

76m m (3)

SUG GESTED

MIN IMUM

114 mm

(4- 1/2)

127 mm

(5)

654 mm

(25 -3/4)

76m m (3)

432 mm

(17 )

241 mm

(9- 1/2)

127 mm

(5)

114 mm

(4- 1/2)

SUP PLIES

AS REQUIR ED

C/L OF DR AIN O UTLET

362 mm

(14 -1/4)

C/L OF 3/ 8 HOT & COL D INLE TS

203 mm

(8)

102 mm

(4)

FIN ISHED

WAL L

COU PLING

NUT S ON

FIT TING

359 mm

(14 -1/8)

29m m (1-1 /8) D IA. HO LE FOR SPRAY

44m m (1-3 /4) D IA. ST D. DRA IN OUT LET

C/L

64m m

(2- 1/2)

19m m (3/ 4)

C/L OF (2 ) 8mm (5/16 ) DIA. FOOT ANC HOR HO LES O N 76mm (3") CENTE RS

(3) 35mm (1-3/ 8) DIA . VAL VE HOL ES

25m m (1) DIA. HOLE

FOR POP-U P ROD

FIN ISHED FLO OR

1-1 /4 O.D . TAI LPIECE

241 mm

(9- 1/2)

REF .

279m

( 11

)

HAN GER

VACUUM BREAKE R

73mm (2-7/8 )

MIN.

❑ 5032.026 For deck-mounted tting (illustrated)

• Vitreous china

• Flushing rim and vertical cleansing spray

• Integral overow

• Concealed oor anchor bracket

• Two bolt caps

Shown with 2373.401 Eneld tting with handles (not included)

❑ 5032.010 For over-the-rim tting

• Vitreous china

• Punched for single hole, over-the-rim tting, less ushing rim and spray

• Integral overow

• Two bolt caps

Nominal Dimensions: 654 x 359 x 362mm (25-3/4" x 14-1/8" x 14-1/4")

HERITAGE™ BIDET

VITREOUS CHINA

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.2M for Vitreous China Fixtures

To Be Specied:

❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Bidet Fitting*: ❏ Fitting Finish: ❏ Trap: ❏ Supplies with Stops:

* See faucet section for additional models available

NOTES:

DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES ARE SUGGESTED.

“P” TR AP AND FIT TINGS NOT FURNISHED WITH BIDET AND MUST BE ORDERED SEPARATELY. BIDET FITTING HAS TRANSFER VALVE FEATURE.

● REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH BIDET AND

FITTING FOR ADDITIONAL INFORMATION.

PROVISIONS MUST BE MADE FOR THE INSTALLATION OF TRAP IN FLOOR.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to c hange or cancellation. No responsibility is assumed for use of superseded or voided leaet.

Revised 2/08