American Standard 4223 User Manual
Installation
Instructions
THE
COLLECTION
by
™
4223
Bar Sink Faucet
Thank you for selecting American-Standard...the benchmark of fine
quality for over 100 years.
To ensure that your installation proceeds smoothly--please read
these instructions carefully before you begin.
TOOLS REQUIRED
Basin Wrench
INSTALL FAUCET
1
Insert faucet SHANKS (1) through holes of SINK. Place faucet as far forward as possible.
Turn off hot and cold water supplies before beginning.
CAUTION
Certified to comply with ASME A112.18.1M
M968414
Tubing Cutter
Plumbers' Putty or CaulkingAdjustable WrenchChannel Locks
Secure FAUCET (2) with ATTACHMENT NUTS (3) supplied and hand tighten.
2
PUTTY
PLATE
1
SINK
3
(HAND TIGHTEN)
MAKE WATER SUPPLY CONNECTIONS
2
NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS MUST BE
PURCHASED SEPARATELY.
Connect water supply to FAUCET SHANKS (1) with 1/2" IPS FLEXIBLE
SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3).
Use adjustable wrench to tighten connections. Do not over tighten.
Be careful not to kink copper supply when bending. Use tubing
cutter to cut to proper length.
TEST INSTALLED FITTING
3
With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3).
Operate both HANDLES (1) to flush
water lines thoroughly.
Replace AERATOR (3).
SINK
1
1
2
3
1
SHANK
COUPLING NUT
FERRULE
3
1
2
SERVICE
4
To change direction of handle rotation, proceed as follows:
Turn valve to OFF position.
Pull out INDEX CAP (1) and remove HANDLE SCREW (2).
Pull off HANDLE (3).
Pull off STEM ADAPTER (4).
Remove SPRING CLIP (6).
Lift STOP WASHER (5), turn 90° and replace.
Replace SPRING CLIP (6) and STEM ADAPTER (4).
Reinstall HANDLE ASSEMBLY (1,2 & 3).
If spout drips, operate handles several times from OFF to ON position.
Do not force - handles turn only 90°.
CARE INSTRUCTIONS:
5
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON
FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS,
OR A CLOTH WITH A COARSE SURFACE.
90°
6
1
2
3
4
5
M968414
Loading...