American Standard 4114.016, 2998.014, 4114.600, 4114.800 User Manual

19mm ± 6mm (3/4 ± 1/4 )

356m m

(14)

806m m

(31- 3/4)

C/L OF OUT LET

133m m

(5-1 /4)

FINI SHED W ALL

419m m

(16- 1/2)

470m m

(18- 1/2)

C/L OF SEA T POST HOLES 140m m (5-1 /2 CEN TERS)

311m m

(12- 1/4)

178mm

(7)

16mm

(5/8 )

FINI SHED FLOO R

813m m

(32)

235m m

(9-1 /4)

152m m

(6)

495m m

(19- 1/2)

254m m

(10)

SUPP LY

REQ' D

375m m (14- 3/4)

279m m (11)

MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND USABLE BUILDING FACILITIES-CHECK LOCAL CODES.

CADET™ RIGHT HEIGHT™ 14" ROUGH-IN ELONGATED TOILET

❑ 2998.014

• Vitreous china

• Low-consumption (6.0 Lpf/1.6 gpf)

• 16-1/2" rim height for accessible applications

• 14" roughing-in

• Elongated siphon action jetted bowl

• AquaForce ushing technology

• Fully glazed 2" trapway

• Close-coupled tank with raised lip detail on tank cover

• Color-matched trip lever

• Speed Connect® tank/bowl coupling system

• Sanitary bar on bowl

• 2 bolt caps

• 100% factory ush tested

❑ 3417.016 Bowl ❑ 4114.016 Tank

CADET™ RIGHT HEIGHT™

14" ROUGH-IN ELONGATED TOILET

VITREOUS CHINA

Alternate Tank Congurations Available:

❑ 4114.600 Tank complete with tank cover

locking device

❑ 4114.800 Tank complete with trip lever located

on right hand side

Nominal Dimensions: 806 x 495 x 813mm (31-3/4" x 19-1/2" x 32")

Fixture only, seat and supply by others

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.2M for Vitreous China Fixtures - includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions

To Be Specied:

❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Silver ❏ Fawn Beige ❏ Black ❏ Seat: American Standard #5324.019 “Rise and Shine” solid plastic closed front, seat with cover. ❏ Seat: American Standard #5311.012 “Laurel” molded closed front seat with cover.

❏ Alternate Seat: ❏ Supply with stop:

NOTES:

THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 356mm (14") FROM FINISHED WALL TO C/L OF OUTLET. SUPPLY NOT INCLUDED WITH FIX TURE AND MUST BE ORDERED SEPARATELY.

DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to c hange or cancellation. No responsibility is assumed for use of superseded or voided pages.

K83

Revised 2/08