American Standard 2740.102, 2740.218, 2740.202, 2740.118 User Manual

COLONY™ 5’ X 30” w/INTEGRAL APRON

WHIRLPOOL AND BATHING POOL

HIGH GLOSS ACRYLIC

COLONY 5’ x 30” WHIRLPOOL AND BATHING POOL with INTEGRAL APRON

❏ 2740.118 Whirlpool, Right Hand Outlet ❏ 2740.218 Whirlpool, Left Hand Outlet

Product Features:

• High Gloss Acrylic with fiberglass reinforcement

• Integral apron with removable access panel

• Integral three-sided, tiling/water retention flange

• Integral lumbar support

• Molded-in arm rests with elbow supports

• Safety textured tub bottom pattern

Factory installed and tested whirlpool system featuring:

• Rigid P.V.C. piping

• 1 H.P. self-draining pump/motor with Dry Run seal

• Six multi-direction jets

• One air volume control

• Anti-vortex suction fitting

• Deck mounted air switch On/Off control

• U.L.® Listed entire whirlpool system

❏ 2740.102 Bath only, Right Hand Outlet ❏ 2740.202 Bath only, Left Hand Outlet

• Same as above without whirlpool system

Nominal Dimensions: (59-7/8” x 29-7/8” x 19-1/4") 1521 x 759 x 489mm

BV-018B

12/99

SPS 2740

To Be Specified - :

❏ Color: ❏ Bath/Shower Faucet*: ❏ Faucet Finish: ❏ Bath Drain: 1553.270

❏ 002 Chrome ❏ 099 Polished Brass

* See faucet section for models available

NOTE: Roughing-in dimensions and product specifications shown on reverse side of page.

Compliance Certifications Meets or Exceeds the Following Specifications:

• Underwriters Laboratories - Hydromassage Bathtubs UL 1795

• ASME A112.19.7M for Whirlpool Appliances

• ANSI Z124.1 for Plastic Bathtubs

• ASTM E162 for Flammability

• NFPA 258 for Smoke Density

COLONY™ 5’ X 30” w/INTEGRAL APRON

WHIRLPOOL AND BATHING POOL

HIGH GLOSS ACRYLIC

NOTES:

BATH TO BE INSTALLED ABOVE FLOOR LINE AS A RECESS INSTALLATION.

■ REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION. BATH TO BE INSTALLED ABOVE FLOOR LINE AS A RECESS INSTALLATION. LEFT HAND OUTLET SHOWN, RIGHT HAND REVERSE DIMENSIONS (2740.118). FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY. PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.

IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standards Z124.1 and A112.19.7.

These measurements are subject to change or cancellation. No

responsibility is assumed for use of superseded or voided pages.

6-1/4

(159mm)

C/L OF DRAIN

(19mm)

FINISHED

WALL

SEE FITTING

SPECS FOR

DIMENSIONS

1-1/2 O.D.

TAILPIECE

29-7/8

(759mm)

C/L OF

SUPPLIES

HORIZONTAL TAILPIECE

ABOVE FLOOR OUTLET

1-1/2 (38mm)

OPTIONAL TO

FINISHED FLOOR

USUALLY BETWEEN

65 & 78

(1651 & 1981mm)

TOP OF

3/4

DECK

ROUGH

FLOOR

7/8 WATER

RETENTION

FLANGE

(3 SIDES)

C/L OF OVERFLOW

(76mm)

19-1/4

(489mm)

3-3/4

(95mm)

BATH SUPPORT

MATERIAL

59-7/8

(305mm)

OPT.

(1521mm)

(102mm)

C/L OF SHOWER ARM

FINISHED

■ LEVELING STRINGER NOT FOR SUPPORT

WATER RETENTION FLANGE (3 SIDES)

WALL

C/L OF VALVES

C/L OF SPOUT

2-1/2

(64mm)

(483mm)

14-1/8

(359mm)

UNDERSIDE OF DECK

59-7/8

(1521mm)

(1) AIR VALVE

(6) JETS

(305mm)

OPT.

(102mm)

WATER RETENTION FLANGE (3 SIDES)

PUMP

ACCESS TO PUMP/MOTOR THROUGH REMOVABLE FRONT ACCESS PANEL

C/L OF SHOWER ARM

FINISHED

WALL

C/L OF VALVES

C/L OF SPOUT

■ LEVELING STRINGER NOT FOR SUPPORT

(483mm)

2-1/2

(64mm)

14-1/8

(359mm)

ON/OFF SWITCH

UNDERSIDE OF DECK

HORIZONTAL TAILPIECE

6-1/4

(159mm)

C/L OF DRAIN

(19mm)

FINISHED

WALL

SEE FITTING

SPECS FOR

DIMENSIONS

1-1/2 O.D.

TAILPIECE

29-7/8

(759mm)

C/L OF

SUPPLIES

ABOVE FLOOR OUTLET

1-1/2 (38mm)

OPTIONAL TO

FINISHED FLOOR

USUALLY BETWEEN

65 & 78

(1651 & 1981mm)

TOP OF

3/4

DECK

ROUGH

FLOOR

7/8 WATER

RETENTION

FLANGE

(3 SIDES)

C/L OF OVERFLOW

(76mm)

19-1/4

(489mm)

3-3/4

(95mm)

BATH SUPPORT

MATERIAL

GENERAL SPECIFICATIONS FOR 2740 WHIRLPOOL

INSTALLED SIZE WEIGHT WEIGHT w/WATER GAL. TO OVERFLOW WHIRLPOOL MIN. OPERATING VOL. BATHING WELL AT SUMP BATHING WELL AT RIM WATER DEPTH TO OVERFLOW FLOOR LOADING (PROJECTED AREA) PTS.

CUBE (FT

)

59-7/8 x 29-7/8 x 19-1/4 (1521 x 759 x 489mm)

25-1/2 x 55-1/2(648 x 1410mm )

39 Lbs./Sq.Ft. (188 Kgs./Sq.m)

105 Lbs. (47 Kgs.)

480 Lbs. (216 Kgs.)

45 Gal. (171 L) 38 Gal. (144 L)

20 x 46 (508 x 1168mm )

11-1/2 (292mm)

WHIRLPOOL ELECTRICAL SPECIFICATIONS

SYSTEM I PUMP 1 HP, 9.9 AMPS,120V.

GENERAL SPECIFICATIONS FOR 2740 BATHING POOL

59-7/8 x 30 x 19-1/4 (1521 x 762 x 489mm)

25-1/2 x 55-1/2(648 x 1410mm )

16.7

33.0

INSTALLED SIZE WEIGHT WEIGHT w/WATER GAL. TO OVERFLOW BATHING WELL AT SUMP BATHING WELL AT RIM WATER DEPTH TO OVERFLOW FLOOR LOADING (PROJECTED AREA) PTS.

CUBE (FT

)

70 Lbs. (32 Kgs.)

462 Lbs. (208 Kgs.)

47 Gal. (178 L)

20 x 46 (508 x 1168mm )

37 Lbs./Sq.Ft. (179 Kgs./Sq.m)

11-1/2 (292mm)

16.7

33.0