American Standard 2586.000 User Manual

CHAMPION® 4 RIGHT HEIGHT™

MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND USABLE BUILDING FACILITIES-CHECK LOCAL CODES.

FIN ISHE D WALL

32m m ± 6mm (1- 1/4 ± 1/4)

419 mm

(16 -1/2 )

FIN ISHE D FLO OR

305 mm

(12 )

772 mm (30 -3/8 )

C/L OF OUTLET

83m m

(3- 1/4)

235 mm (9- 1/4)

470 mm

(18 -1/2 )

C/L OF SEAT P OST HO LES 140 mm ( 5-1/2 CENTER S)

362 mm (14 -1/4 )

264mm

(10-3/8)

16m m

(5/ 8)

825 mm

(32 -1/2 )

464 mm

(18 -1/4 )

SUP PLY

REQ 'D

254 mm

(10 )

152 mm

(6)

254 mm

(10 )

356 mm

(14 )

ELONGATED TOTAL TOILET

❑ 2586.000

• Vitreous china

• EverClean® surface inhibits the growth of stain and odor causing bacteria, mold and mildew on the surface

• Low-consumption (6.0 Lpf/1.6 gpf)

• Features Champion® 4 Flushing System

performance platform

• 4" non-adjustable, piston action Accelerator™ ush valve

• 16-1/2" rim height for accessible applications

• Elongated siphon action jetted bowl

• 2-3/8" fully-glazed trapway

• Speed Connect® tank/bowl coupling system

• Chrome-plated trip lever

• Sweeping pier on bowl

• 100% factory ush tested

• 2 bolt caps

• Color-matched plastic toilet seat and cover with EverClean® surface

• Wax ring gasket with closet bolts

• 10 year warranty

CHAMPION® 4 RIGHT HEIGHT™

ELONGATED TOTAL TOILET

VITREOUS CHINA

Nominal Dimensions:

772 x 464 x 825mm (30-3/8" x 18-1/4" x 32-1/2")

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.2M for Vitreous China Fixtures includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions

• Los Angeles Department of Water and Power Supplementary Purchase Specication for Non-Adjustability - July, 2003 revision

To Be Specied:

❏ Color: ❏ White ❏ Supply with stop:

NOTES:

THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET. SUPPLY NOT INCLUDED WITH FIX TURE AND MUST BE ORDERED SEPARATELY.

DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.

IMPORTANT: Dimensions of xtures are nominal and may var y within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.

K105

Revised 2/08