American Standard 2034.014 User Manual

CHAMPION® 4 ELONGATED RIGHT HEIGHT™

MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND USABLE BUILDING FACILITIES-CHECK LOCAL CODES.

When installed, top of seat meets minimum requirement of 432 to 483mm (17" to 19") from the finished floor.

•

756mm (29-3/4)

203mm

(8)

44mm (1-3/4)

32mm

(1-1/4)

419mm (16-1/2)

343mm (13-1/2)

273mm

(10-3/4)

749mm (29-1/2)

425mm (16-3/4)

451 mm

(17 -3/ 4)

FINISHED WALL

25mm

(1)

470mm (18-1/2)

C/L OF SEAT POST HOLES 140mm (5-1/2) CENTERS

305mm

(12)

C/L OF OU TL ET

13mm

(1/2)

273mm (10-3/4)

114mm

(4-1/2)

SUPPLY

REQ'D

FINISHED FLOOR

178mm

(7)

95mm (3-3/4)

ONE-PIECE TOILET

❑ 2034.014

• Vitreous china

• EverClean® surface inhibits the growth of stain- and odor-causing bacteria, mold, and mildew on the surface

• Low-consumption (6.0 Lpf/1.6 gpf)

• Features Champion® 4 Flushing System

performance platform

• 4" non-adjustable, piston action Accelorator™

ush valve

• 16-1/2" rim height for accessible applications

• Elongated siphon action jetted bowl

• 2-3/8" fully-glazed trapway

• Chrome trip lever

• 100% factory ush tested

• 2 bolt caps

• 10 year warranty

Nominal Dimensions: 756 x 451 x 749mm (29-3/4" x 17-3/4" x 29-1/2")

CHAMPION® 4 ELONGATED

RIGHT HEIGHT™ ONE-PIECE TOILET

VITREOUS CHINA

Fixture only, seat and supply by others

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.2M for Vitreous China Fixtures includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions

To Be Specied:

❏ Color: ❏ White ❏ Bone ❏ Silver ❏ Linen ❏ Black

❏ Trip Lever 738772-XXX0A: ❏ 002 Chrome (supplied) ❏ 068 Blackened Bronze ❏ 099 Polished Brass ❏ 295 Satin Nickel ❏ Seat: ❏ Champion® Slow Close Elongated #5325.010 ❏ EverClean® Elongated Seat, with Cover and

❏ Supply with Stop (by other):

Slow Close Snap-Off Hinges #5321.110

NOTES:

THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET. SUPPLY NOT INCLUDED WITH FIX TURE AND MUST BE ORDERED SEPARATELY.

DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to c hange or cancellation. No responsibility is assumed for use of superseded or voided pages.

Revised 2/08