American Standard 1660.14, 1660.13 User Manual

Installation

Instructions

LUXURY SHOWER

EXTENDER BODY SPRAYS

Thank you for selecting American-Standard...the
benchmark of fine quality for over 100 years.

To ensure that your installation proceeds smoothly-­please read these instructions carefully before you begin.

Recommended Tools

1660.130

1660.140

1660.130 1660.140

Certified to comply with ANSI A112.18.1

M968617 Rev.1.2

Flat Blade Screwdriver

ROUGHING-IN DIMENSIONS

ALL CONNECTIONS 1/2" NPT

74mm D.

(2-15/16")

1660.130 Multifunction
Round Body Spray

26mm

(1")

2-1/4" DIA.

(57mm) Hole Saw

(75.6-82.6mm)

2-15/16" - 3-1/4"

12mm

(1/2")

75mm

(3")

Teflon Tape

Electric Drill

1660.140 Multifunction
Square Body Spray

15°

FINISHED WALL

54mm D.

(2-1/8")

57mm D.

(2-1/4")

HOLE SIZE

(63.6-70.6mm)

2-1/2" - 2-3/4"

35mm

(1-3/8")

1/2" NPT

INSTALL SUPPLY PIPING

1

Provide a “Installation Hole” 2-1/8" - 2-3/8" DIA., (54-60mm) and 3-1/4", (83mm) deep. Note: The “Installation Hole”
must be clear to allow body spray clearance.
Install the ELBOW (1) on a support within the wall at the *dimension shown. Secure with
two M5 SCREWS (2) (not provided).

83mm

54-60mm

(2-1/8" - 2-3/8" DIA.)

(3-1/4")

CAUTION

1

{

“Installation Hole”

2

Turn off hot and cold water
supplies before beginning.

54-60mm

(2-1/8" - 2-3/8" DIA.)

“Installation Hole”

FINISHED WALL

82.6mm
(3-1/4")

2

*63.6-70.6mm

(2-1/2" - 2-3/4")

*75.6-82.6mm

(2-15/16" - 3-1/4")

WALL SUPPORT

1

INSTALL PLASTER GUARD

2

Make sure the O-RING (3) is installed on the PLASTER GUARD (1).

Install the PLASTER GUARD (1) into ELBOW (2). Note: The finished wall must be between the Min. & Max.
lines on the PLASTER GUARD (1).

Complete all tiling and wall work. When walls are finished remove PLASTER GUARD (1).

FINISHED WALL

1

MAX.

(LINE MARK)

MINIMUM

(LINE MARK)

REMOVE

INSTALL

3

1

2

3

2

M968617 Rev.1.2