American Standard 1480.115, 1480.110 User Manual

Installation
Instructions
SEVA
Centerset Lavatory Faucet with
SpeedConnect™ Drain
Congratulations on purchasing your American Standard faucet with Speed Connect drain, a feature found only on American Standard faucets.
1480.110
1480.115
Speed Connect™ Drain*
• Fewer parts, installs in less time
• Never needs adjustment
• Guaranteed to seal properly the first time, every time. *Your new American Standard faucet is designed to work only with the Speed Connect drain. Heplful tips for
removing your current drain can be found in the Troubleshooting section of these instructions.
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
Required tools
Certified to comply with ANSI A112.18.1
M968305 REV. 1.1
1
INSTALL FAUCET
CAUTION
Turn off hot and cold water supplies before beginning.
Note: Putty is not required unless mounting surface is uneven.
Apply a bead of PUTTY along the edge of the underside of the BODY (1) if required.
Insert FAUCET (1) and CABLE CONNECTOR (2) through mounting holes of Sink or mounting surface.
Assemble LOCKNUTS (3) onto SHANKS (4) from under side of Sink. Hand tighten firmly.
Turn off water at
main supply.
Fig. B.
(HAND TIGHTEN)
Fig. A.
3
1
PUTTY
(IF REQUIRED)
Fig. A.
POP-UP CABLE
Tubing Cutter
4
Fig. B.
4
SINK OR
MOUNTING
SURFACE
3
2
1
2
POP-UP DRAIN
2
Fig. A. Fig. B.
Remove CLEAR PLASTIC COVER (1).
Remove CARDBOARD SPACER (2) from under DRAIN POP-UP (3).
Tighten TAILPIECE (4) on DRAIN BODY before installing DRAIN BODY.
REMOVE FLANGE
3
Thread FLANGE (1) counter-clockwise and remove FLANGE (1) and FOAM GASKET (2) from drain body.
Fig. A.
Thread LOCKNUT (3) clock-wise to bottom of drain body. Push GASKET (4) down against LOCKNUT (3).
Fig. B.
Fig. B.
1
3
2
Fig. A. Fig. B.
1
2
4
3
DRAIN BODY
4
INSTALL DRAIN FROM
4
BELOW FIXTURE
From under side of SINK install DRAIN BODY (1) up through drain outlet.
Note: No plumber’s putty or caulk is required. The CABLE ATTACHMENT POINT (2) must face towards the rear of the SINK.
Install FOAM GASKET (3) and FLANGE (4) onto drain body from above SINK and tighten FLANGE (4) firmly.
FLANGE GASKET AND POP-UP KNOB
6
Check DRAIN FLANGE in SINK to ensure that WHITE FOAM GASKET (3) is fully compressed and not visible. Fig. A.
POP-UP KNOB (1) must be fully down. Fig. B.
TIGHTEN LOCKNUT
REAR OF SINK
4
DRAIN OUTLET
5
Tighten LOCKNUT (1) firmly with Adjustable Wrench or Channel Locks.
3
1
1
2
Fig. A. Fig. B.
DOWN
1
WHITE FOAM GASKET NOT VISIBLE
DRAIN FLANGE
M968305 REV. 1.1
2
Loading...
+ 2 hidden pages