American Standard 0268.800, 0268.400, 0268.100 User Manual

(508mm)

20-1/4 (514mm)

3-1/4

(83mm)

4 (102mm)

(203mm)

FINISHED WALL

5-1/4 (133mm)

PEDESTAL ANCHORING

SCREW HOLES 5/16 (8mm) DIA.

PEDESTAL TO WALL

3/4 " (19m m) DI A. HOL ES FOR ANC HOR BO LTS

(864mm)

REF.

OPEN

FLOOR

24-1/2

(622mm)

9-3/8

(238mm)

REF.

(203mm)

OPTIONAL

TOWEL BAR

(178mm)

20-1/2

(521mm)

(584 mm)

1-1 /4 O.D . WAS TE

1-1 /4 O.D . TAI LPIECE

SUP PLIES AS REQ'D

FINISHED FLOOR

8 (203mm)

6-1/2 (165mm)

DRAIN

CHASE

PEDESTAL

SIDE SECTION

RAVENNA™ PEDESTAL SINK

• Contemporary sleek design

• Made from vitreous china

• Rear overow

• Faucet ledge with generous shelf area

• Supplied with mounting kit

• Optional integral mounted towel bar (ordered separately, installed by customer)

• Shown with 2000.101 Ceramix single lever faucet (not included)

❏ 0268.800 Faucet holes on 8" (203mm) centers ❏ 0268.400 Faucet holes on 4" (102mm) centers ❏ 0268.100 Center faucet hole only

Nominal Dimensions: 24-1/4" x 20" x 34" (616 x 508 x 864mm)

RAVENNA™

PEDESTAL SINK

VITREOUS CHINA

Separate Components:

❏ 0268.008 Pedestal top-8" (203mm) centers ❏ 0268.004 Pedestal top-4" (102mm) centers ❏ 0268.001 Pedestal top-Center hole only ❏ 0041.000 Pedestal only

Bowl sizes: 19-3/8" (492mm) wide 11-7/8 (302mm) front to back 6" (152mm) deep

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.2M for Vitreous China Fixtures

• CAN/CSA B45 Series

* See faucet section for additional models available

Recommended Component:

❏ Integral Towel Bar: 3520.000 (Specify 002 Chrome or 295 Satin Nickel)

To Be Specied:

❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Black ❏ Faucet*: ❏ Faucet Finish: ❏ Supplies: ❏ 1-1/4" Trap:

NOTES:

DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TR AP ARE

SUGGESTED.

▼ PEDESTAL ANCHORING SCREWS NOT INCLUDED.

■ SUITABLE FOR REINFORCEMENT ONLY. ACTUAL DIMENSIONS MUST

BE TAKEN FROM FIXTURE. FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY. PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS. INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to c hange or cancellation. No responsibility is assumed for use of superseded or voided pages.

J13

Revised

Revised 2/08