American Fibertek RRM-1400 User Manual

Video Receiver With

Bi-directional RS422 Data

Instruction Manual

RRM-1400

INSTALLATION AND OPERATION INSTRUCTIONS

INTRODUCTION

Thank you for purchasing your American Fibertek RRM-1400 multimode video receiver. Please take a few minutes to read these installation instructions in order to obtain the maximum performance from this product.

FUNCTIONAL DESCRIPTION

The RRM-1400 operates as half of a transmitter / receiver pair for the transmission of baseband NTSC, PAL, RS170, or RS343 video signals with bi-directional RS422 data. It is designed to operate with the MTM-1400 or RTM-1400 video transmitter over a single multimode fiber optic cable.

The RRM-1400 converts an optical fiber input into a single video output and a single RS422 output using a 1300 nm wavelength detector. The RRM-1400 also converts an electrical RS422 input signal into an optical RS422 output returning on the same fiber using an 850 nm wavelength source. The 1400 Series product is designed to operate over an optical loss budget range of 0 to 12 dB. The RRM-1400 operates on 50 um or

62.5 um multimode fiber. Refer to the data sheets for detailed performance specifications.

This unit is designed for rack mounting in any of the three American Fibertek subracks available. The subrack model numbers are SR-20/1, SR-20R/1, and SR-20/2. Slide in rack mounting and LED indicator provide for easy installation and monitoring of video and power.

The RRM-1400 is designed for rack mounting only. For a modular version please see the MRM-1400.

INSTALLATION

THIS INSTALLATION SHOULD BE MADE BY A QUALIFIED SERVICE PERSON AND SHOULD CONFORM TO THE NATIONAL ELECTRICAL CODE, ANSI/NFPA 70 AND LOCAL CODES.

The unit slides into any open slot in the SR-20 subrack. Use a small screwdriver to push and lock the two ¼ turn fasteners into place.

POWER SOURCE

Power to the unit is supplied by the subrack. Please refer to the SR-20 and PSR instructions for further details.

POWER CONNECTION

Power is supplied to the unit via a four finger backplane connector. The RRM-1400 can be inserted into the subrack or removed from the subrack with power applied to the backplane.

+ 2 hidden pages