American Fibertek RR-940CD-SL User Manual

6/15/13 JPK

Instruction Manual

RR-940CD-SL

Four Channel Video Receiver

INSTALLATION AND OPERATION INSTRUCTIONS

INTRODUCTION

Thank you for purchasing your American Fibertek RR-940CD-SL singlemode four channel video
transmitter. Please take a few minutes to read these installation instructions in order to obtain
the maximum performance from this product.

FUNCTIONAL DESCRIPTION

The RR-940CD-SL operates as half of a transmitter / receiver pair for the transmission of four
channels of high performance digital NTSC, PAL, RS170, or RS343 video signals. The RR­940CD-SL is designed to operate with the MT-940CD-SL or RT-940CD-SL video transmitter
over one singlemode fiber optic cable.

The RR-940CD-SL de-multiplexes four video input signals from a high speed serial data stream.
This serial data stream is detected on a 1310 nm wavelength. Refer to the data sheets for
detailed performance specifications.

This unit is designed for rack mounting in any of the three American Fibertek subracks
available. The subrack model numbers are SR-20/2 and SR-20H/2. Slide in rack mounting and
LED indicators provide for easy installation and monitoring of video and power.

The RR-940CD-SL is designed for rack mounting only. For a modular stand alone version
please see the MR-940CD-SL.

INSTALLATION

THIS INSTALLATION SHOULD BE MADE BY A QUALIFIED SERVICE PERSON AND
SHOULD CONFORM TO THE NATIONAL ELECTRICAL CODE, ANSI/NFPA 70 AND LOCAL
CODES.

Mount the unit to a secure surface using #8 (3mm) hardware in four places. See the drawing on
the next page for mounting dimensions. Be sure to allow sufficient room for the required
minimum bend radius of the fiber cable used.

2