American Fibertek RR-93200D-SL User Manual
© Copyright 2006, American Fibertek, Inc. 11109JD
Thirty Two Channel Video Multiplexer
With Remote Diagnostic Interface
Instruction Manual
RT-93200D-SL
RR-93200D-SL
INSTALLATION
THIS INSTALLATION SHOULD BE MADE BY A QUALIFIED SERVICE PERSON AND
SHOULD CONFORM TO THE NATIONAL ELECTRICAL CODE, ANSI/NFPA 70 AND LOCAL
CODES.
Table of Contents
Functional Description ........................................................................3
RT-93200D-SL Components...............................................................3
RR-93200D-SL Components..............................................................4
Power Connections.............................................................................5
Fiber Connections...............................................................................5
Video Input / Output Connections.......................................................5
RT-980D Series Status LED Indicators...............................................6
RR-980D Series Status LED Indicators..............................................7
Warranty / Service Information ...........................................................8
2
INSTALLATION AND OPERATION INSTRUCTIONS
INTRODUCTION
Thank you for purchasing your American Fibertek Series 93200D-SL singlemode thirty two
channel video multiplexer. Please take a few minutes to read these installation instructions in
order to obtain the maximum performance from this product.
FUNCTIONAL DESCRIPTION
The 93200D-SL Series units operate as a transmitter / receiver pair for the digital transmission
of thirty two simultaneous NTSC or PAL video signals over one singlemode fiber optic cable.
The RT-93200D-SL transmitter accepts up to thirty two video inputs in four groups containing
eight videos each. The eight videos from each group are multiplexed into a high speed serial
data stream. The first group’s serial data stream modulates a laser at 1470nm wavelength. The
second group’s serial data stream modulates a laser at 1490nm wavelength. This pattern is
repeated for group’s three and four using wavelengths 1510nm and 1530nm respectively. A
Course Wave Division Multiplexer (CWDM) combines these four wavelengths onto a single
optical output port for connection to the fiber transmission system. Correspondingly, the RR93200D-SL receiver converts the optical signal to thirty two independent video outputs.
The 93200D-SL Series product is designed to operate over an optical loss budget range of 0dB
to 21dB on 9um singlemode fiber. Refer to the product specification sheet for additional
performance data.
The RD-20D diagnostic card in each subrack enables the status of the RT-93200D-SL and the
RR-93200D-SL components to be monitored locally or via a remote PC. Please refer to the RD20D installation manual for set up and operating instructions for remote status monitoring.
RT-93200D-SL COMPONENTS
The RT-93200D-SL consists of the following components:
1) RT-980D-1470 1) RT-980D-1530 1) SR-20D 1) BPS-1
1) RT-980D-1490 4) PCSC/UPC-0.3 1) PSR-2 1) BPS-2
1) RT-980D-1510 1) RT-CWDM-4 1) RD-20D
The individual 980D series video rack cards that make up the RT-93200D-SL are combined in a
rack mount configuration using the SR-20D subrack. Please refer to the instruction manuals for
the SR-20D and the PSR-2 for information on the installation of the subrack with its power
supply. The individual 980D series rack cards can slide into any two adjacent open slots in the
SR-20D subrack, however, the recommended configuration is shown on the next page. Use a
small screwdriver to push and lock the four ¼ turn fasteners into place.
3
Loading...