American Fibertek RR-93200C-SL User Manual
f
f
f
f
f
f
f
a f i
a
i a f i
a
i
a
a
i
i
a
i afi
afi
a
i
a
a
i
f i
Instruction Manual
RT-93200C-SL
RR-93200C-SL
Thirty Two Channel Video Multiplexer
10/30/2012 JPK
INSTALLATION
THIS INSTALLATION SHOULD BE MADE BY A QUALIFIED SERVICE PERSON AND
SHOULD CONFORM TO THE NATIONAL ELECTRICAL CODE, ANSI/NFPA 70 AND LOCAL
CODES.
Table of Contents
Functional Description ........................................................................3
RT-93200C-SL Components...............................................................3
RR-93200C-SL Components..............................................................4
Power Connections.............................................................................4
Fiber Connections...............................................................................5
Video Input / Output Connections.......................................................5
RT-980C Series Status LED Indicators...............................................6
RR-980C Series Status LED Indicators..............................................7
Warranty / Service Information ...........................................................8
2
INSTALLATION AND OPERATION INSTRUCTIONS
f
f
f
f
f
f
INTRODUCTION
Thank you for purchasing your American Fibertek Series 93200C-SL singlemode thirty two
channel video multiplexer. Please take a few minutes to read these installation instructions in
order to obtain the maximum performance from this product.
FUNCTIONAL DESCRIPTION
The 93200C-SL Series units operate as a transmitter / receiver pair for the digital transmission
of thirty two simultaneous NTSC or PAL video signals over one singlemode fiber optic cable.
The RT-93200C-SL transmitter accepts up to thirty two video inputs in four groups containing
eight videos each. The eight videos from each group are multiplexed into a high speed serial
data stream. The first group’s serial data stream modulates a laser at 1470nm wavelength. The
second group’s serial data stream modulates a laser at 1490nm wavelength. This pattern is
repeated for group’s three and four using wavelengths 1510nm and 1530nm respectively. A
Course Wave Division Multiplexer (CWDM) combines these four wavelengths onto a single
optical output port for connection to the fiber transmission system. Correspondingly, the RR93200C-SL receiver converts the optical signal to thirty two independent video outputs.
The 93200C-SL Series product is designed to operate over an optical loss budget range of 0dB
to 21dB on 9um singlemode fiber. Refer to the product specification sheet for additional
performance data.
RT-93200C-SL COMPONENTS
The RT-93200C-SL consists of the following components:
1) RT-980C-1470 1) RT-980C-1530 1) SR-20
1) RT-980C-1490 4) PCSC/UPC-0.4 1) PSR-2
1) RT-980C-1510 1) RT-CWDM-4 2) BPS-2
The individual 980C series video rack cards that make up the RT-93200C-SL are combined in a
rack mount configuration using the SR-20 subrack. Please refer to the instruction manuals for
the SR-20 and the PSR-2 for information on the installation of the subrack with its power supply.
The individual 980C series rack cards can slide into any two adjacent open slots in the SR-20
subrack, however, the recommended configuration is shown on the next page. Use a small
screwdriver to push and lock the four ¼ turn fasteners into place.
a
i
a
i
a
i
a
ia
3
i
a
i
Loading...