(2) 10/100 Base-T & (2) 100Base-FX Ethernet 4 Port
Switch / Drop & Repeat Transceiver with 60W PoE
“Approved for AXIS Q6032-E PTZ Dome Network Camera”
FEATURES:
Complete Fiber Optic to Twisted Pair
Media Interface
Drop and Repeat Capability
Auto MDI / MDIX Detection
Auto Negotiate 10/100 Ports
Link and Activity Indicators for UTP
and Fiber Ports
Multimode Fiber
Power (60 Watts) Over Ethernet on
1 Port
Two RJ45 Data Ports Available
Extended Temperature Range
SPECIFICATIONS:
Ethernet:
Data Rate
Auto negotiated ..........10/100 Mb/s
Connector................................ RJ45
PoE (1 port) ……………..…60 Watts
Optical:
One Fiber ..................1310/1550 nm
Two Fiber........................... 1310 nm
Loss Budget............................ 11 dB
Distance...................................2 Km
Connector............................. SC, ST
Power:
Voltage.................................48 VDC
Current................................ 200 mA
Connector........2 Pin Terminal Block
Recommended Power Supply:
48VDC @ 60W (Sold separately)
Environmental:
Temperature.......... -40 °C to +75 °C
Humidity........................ 5 % to 95 %
Size:
Module................... 4.3” x 4.3” x 1.2”
Power Supply........ 4.6” x 3.6” x 1.6”
10/23/13 JPK
The American Fibertek 50-PoE-HP Series transmits and receives (2) copper
10/100 Base-T Ethernet signals at the RJ45 ports and (1) optical 100 BaseFX over 1 or 2 multimode fibers. The system is comprised of two units
forming a point-to-point communications link.
The 46-PoE-HP Series also sources up to 60 Watts of power to an Ethernet
powered device (PD) from one RJ45 port. The power is carried over all 4
pairs of the Ethernet cable. However, it is required that the PD have
independent discovery and classification interfaces for both the data pair and
the spare pair of the Ethernet cable.
Both RJ45 ports may be used to deliver Ethernet data to devices. An external
power supply is required.
The system is designed to be completely transparent with auto negotiation
features which automatically configure the unit for the correct speed (10/100
Base-T). Auto MDI/MDIX operation eliminates the potential need for
crossover cables. Diagnostic indicators provide a quick visual indication of
system status.
ORDERING INFORMATION:
MX-50-FX-1F-SC-PoE-HP One Fiber/Port, Module FX Multimode SC Connector
MX-50-FX-1F-ST-PoE-HP One Fiber/Port, Module FX Multimode ST Connector
MX-50-FX-SC-PoE-HP Two Fiber/Port, Module FX Multimode SC Connector
MX-50-FX-ST-PoE-HP Two Fiber/Port, Module FX Multimode ST Connector
POWER SUPPLY:
PS-4860 Universal Input to 48V 60W Output -40 to 75°C
The PoE module is typically used only at the system edge (to power the camera etc.).
The mating unit would then be the non PoE version of the product which is available in
module or rack card packages.
50-PoE-HP
SERIES
MULTIMODE