American Fibertek MX-48-SX-ST, MX-48-LX-ST, MX-48-LX-SL-ST, MTX-48-LX-ST, MTX-48-LX-SL-ST User Manual

2012_4_1JPK

Instruction Manual

Series-48

Ethernet

Data Transceiver

INSTALLATION AND OPERATION INSTRUCTIONS

INTRODUCTION

Thank you for purchasing your American Fibertek Series 48 Series Ethernet data transceiver. Please
take a few minutes to read these installation instructions in order to obtain the maximum performance
from this product.

FUNCTIONAL DESCRIPTION

The Series 48 Transceiver operates as a 3 port Ethernet switch / media converter. It has two copper
ports that support triple speed (10/100/1000 BASE-T) Ethernet data and one fiber port that operates at
1000 Base-X over Singlemode or Multimode fiber optic cable. Auto MDI/MDIX operation on the copper
ports eliminates the potential need for crossover cables.
either 10/100/100 Base-T Ethernet data at full or half duplex The fiber port is available in the following
options (see datasheets for more detail).

- 1 fiber or 2 fiber optical connections

- SX (short range), LX (long range) versions

- SC or ST optical connectors

- Multi-mode or Singlemode

- Modules or Rackcards.

INSTALLATION

THE INSTALLATION OF THIS UNIT SHOULD BE MADE BY A QUALIFIED SERVICE PERSON(S)
AND MUST CONFORM TO ALL LOCAL CODES.

Mount the unit to a secure surface using #8 (3mm) hardware in four places. See the drawing on the
next page for mounting dimensions. Be sure to allow sufficient room for the required minimum bend
radius of the fiber cable used.

POWER SOURCE

This module unit requires a +12VDC power source for proper operation. The DC input is diode
protected. In the USA and in Canada an American Fibertek PS-12 is supplied with this unit. The
negative side of the power input is directly connected to ground. ANSI/NFPA 70 Class 2 wiring is
recommended. Power is supplied to the unit via a two pin terminal connector. Follow label on unit for
proper orientation of +12 volt dc and ground.

The rackcard is powered from a subrack. Refer to the SR-20 and PSR-2 instructions for further details.

FIBER CONNECTION

The fiber optic connection is made via an SC or ST optical connector.

ETHERNET INPUT / OUTPUT CONNECTIONS

The UTP Ethernet input/output connection is made via a RJ45 plug. For optimum performance the
shortest length of UTP wire practical should be used. Ethernet specifications permit a maximum CAT5
wire length of 100 meters.

The Series 48 is configured to auto negotiate

2