American Fibertek MX-46-FX-ST-POE+, MX-46-FX-SL-ST-POE+, MTX-46-FX-ST-POE+, MTX-46-FX-SL-ST-POE+ User Manual
10/01/2012 JPK
Instruction Manual
Series 46 PoE+
Ethernet
Fiber Optic Transceivers
Table of Contents
INTRODUCTION.................................................................................................. 3
FUNCTIONAL DESCRIPTION ............................................................................. 3
MODULE INSTALLATION.................................................................................... 3
PoE+ POWER SUPPLY INSTALLATION............................................................. 3
CONNECTIONS................................................................................................... 3
46 PoE+ SERIES MODULE ................................................................................. 4
46 SERIES RACKCARD ...................................................................................... 4
LED INDICATORS................................................................................................ 5
LED INDICATORS ON THE RJ-45 CONNECTORS............................................ 5
PoE+ POWER SUPPLY ASSEMBLY................................................................... 6
LIFETIME WARRANTY INFORMATION.............................................................. 7
SERVICE INFORMATION.................................................................................... 7
2
INSTALLATION AND OPERATION INSTRUCTIONS
INTRODUCTION
Thank you for purchasing your American Fibertek Series 46 PoE+ Ethernet Fiber Optic Transceiver.
Please take a few minutes to read these installation instructions in order to obtain the maximum
performance from this product.
FUNCTIONAL DESCRIPTION
The Series 46 PoE+ Transceiver operates as a 3 port Ethernet switch / media converter. It has two
copper ports that support triple speed (10/100 BASE-TX) Ethernet data and one fiber port that operates
at 100 Base-FX over Singlemode or Multimode fiber optic cable. Auto MDI/MDIX operation on the
copper ports eliminates the potential need for crossover cables.
following options (see datasheets for more detail).
- 1 fiber or 2 fiber optical connections
- FX (100 Mbs)
- SC or ST optical connectors
- Multi-mode or Singlemode
- Modules or Rackcards
The Series 46 PoE+ also sources power to devices from the RJ45 ports over the copper connection.
Both RJ45 ports may be used to deliver dc power (802.3af 15 watts) to IEEE compatible PD (powered
devices). An external power supply (sold separately) is required. The recommended power supply for
the Series PoE+ is the AFI PS-4860. This power supply is capable of providing up to 30 watts out of
both copper ports on the Series 46 PoE+ modules.
The PoE+ module is typically used only at the system edge (to power the camera etc.). The mating unit
would then be the non PoE+ version of the product which is available in module or rack card packages.
See Series 46 datasheet.
Cat-5e cable is recommended for the connection between the Series 46 PoE+ and the PD equipment.
MODULE INSTALLATION
THE INSTALLATION OF THIS UNIT SHOULD BE MADE BY A QUALIFIED SERVICE PERSON(S)
AND MUST CONFORM TO ALL LOCAL CODES.
Mount the unit to a secure surface using #8 (3mm) hardware in four places. Be sure to allow sufficient
room for the required minimum bend radius of the fiber cable used.
PoE+ POWER SUPPLY INSTALLATION
THE INSTALLATION OF THIS UNIT SHOULD BE MADE BY A QUALIFIED SERVICE PERSON(S)
AND MUST CONFORM TO ALL LOCAL CODES.
Mount the unit to a secure surface using #8 (3mm) hardware in four places.
CONNECTIONS
POWER SOURCE
This Series 46 PoE+ unit requires a +48VDC 60W power source for proper operation. The external PS48V-60W power supply +48V output connects to the module. Power is supplied to the unit via a two pin
terminal connector. Follow label (+ and GND) on the unit for proper orientation of +48 volt dc and
ground.
FIBER PORT CONNECTION
The fiber optic connection is made via an SC or ST optical connector.
3
The fiber port is available in the
Loading...