American Fibertek MR-388S User Manual

© Copyright 2007, American Fibertek, Inc. 0502JD

With Two Channels of Audio

Instruction Manual

MR-388S

Video Receiver

INSTALLATION AND OPERATION INSTRUCTIONS

INTRODUCTION

Thank you for purchasing your American Fibertek MR-388S singlemode video/audio receiver. Please
take a few minutes to read these installation instructions in order to obtain the maximum performance
from this product.

FUNCTIONAL DESCRIPTION

The MR-388S operates as half of a transmitter/receiver pair for the transmission of a one way
baseband NTSC, PAL, RS170, or RS343 video signal with two channels of one way audio. It is
designed to operate with the MT-388S or RT-388S video/audio transmitter over one singlemode fiber
optic cable.

The MR-388S converts an optical input signal into a single video output and two separate audio outputs
using an 1300 nm wavelength detector. The 388S Series product is designed to operate over an optical
loss budget range of 0 to 16 dB. The MR-388S operates on 9 um singlemode fiber. Refer to the data
sheets for detailed performance specifications.

This unit is contained in a compact and rugged aluminum housing with internal dc voltage regulation.
The detachable terminal blocks and LED indicator provide for easy installation and monitoring of
video/audio and dc power.

The MR-388S is designed for mounting as a modular stand alone unit. For a rack mounted version
please see the RR-388S.

INSTALLATION

THIS INSTALLATION SHOULD BE MADE BY A QUALIFIED SERVICE PERSON AND SHOULD
CONFORM TO THE NATIONAL ELECTRICAL CODE, ANSI/NFPA 70 AND LOCAL CODES.

Mount the unit to a secure surface using #8 (3mm) hardware in four places. See the drawing on the
next page for mounting dimensions. Be sure to allow sufficient room for the required minimum bend
radius of the fiber cable used.

POWER SOURCE

THIS PRODUCT SHALL BE POWERED BY A LISTED CLASS 2 POWER SUPPLY ONLY.
This unit requires a 12 volt DC power source for proper operation. In the USA and in Canada an
American Fibertek PS-12 is supplied with this unit. ANSI/NFPA 70 Class 2 wiring is recommended.

2