American Dynamics RHOWCA User Manual

RHOWCA
Corner Mount

For SpeedDome® Ultra or SpeedDome®
Optima Indoor/Outdoor Housings

Installation Guide

Regulatory Compliance: Safety UL1950

Procedure

1. Place the corner bracket in the desired
mounting location and mark holes for four
anchors.

2. Drill holes. For concrete, use anchors
according to diagram.

Parts Supplied

Bracket, Corner 1 0500-9599-01
Install Kit 0351-2145-01

Anchor, Drywall 4 2880-0025-02
Anchor, M6, Wedge w/Hardware 4 2880-0108-01
Washer, Locking, M6 4 5846-0500-020
Washer, Large, M6 4 5842-0500-020
Washer, 6.4mm (¼in) Locking 4 2847-0101-10
Screw, STAP 4 5810-5091-120
Nut, Locking 4 5826-0500-020

Tools Required

• Level

• Power Drill

• Hammer

• Pliers

• Socket Wrench Kit w/Extension (metric)

Extend anchor
threads as shown.

Thread two nuts
back-to-back to
protect the anchor
when hammering it
into the wall.

3. Attach the corner bracket to wall. For
drywall, place lock washers and washers
onto four drywall screws. Thread at least
two screws into the stud. Tighten the
screws. For concrete, use washers, lock
washers and nuts.

15mm (0.6in)

© 2004 Sensormatic

RHOWCA CORNER MOUNT 8000-2692-10, REV. D
INSTALLATION GUIDE

1 of 2

t

4. Bolt the base bracket (supplied separately)
to the corner bracket using washers and
nuts. See instructions supplied with the
wall mounting structure.

Declarations

Thank you for using American Dynamics products. We
support our products through an extensive and worldwide
network of dealers. The dealer, through whom you originally
purchased this product, is your point of contact if you have a
need for service or support. Our dealers are fully empowered
to provide the very best in customer service and support.
Dealers should contact American Dynamics at
[phone] or [phone] or on the web at
www.americandynamics.net.

WARRANTY DISCLAIMER: Sensormatic Electronics
Corporation makes no representation or warranty with respect
to the contents hereof and specifically disclaims any implied
warranties of merchantability or fitness for any particular
purpose.

NOTICE: The information in this manual was current when
published. The manufacturer reserves the right to revise and
improve its products. All specifications are therefore subject to
change without notice.

LIMITED RIGHTS NOTICE: For units of the Department
of Defense, all documentation and manuals were developed at
private expense and no part of it was developed using
Government Funds. The restrictions governing the use and
disclosure of technical data marked with this legend are set
forth in the definition of “limited rights” in paragraph (a) (15)
of the clause of DFARS 252.227.7013. Unpublished - rights
reserved under the Copyright Laws of the United States.

TRADEMARK NOTICE: American Dynamics and
Sensormatic are trademarks or registered trademarks of

Sensormatic Electronics Corporation. Other product names
mentioned herein may be trademarks or registered trademarks
of Sensormatic or other companies.

COPYRIGHT: Under copyright laws, the contents of this
manual may not be copied, photocopied, reproduced,
translated or reduced to any electronic medium or machine­readable form, in whole or in part, without prior written
consent of Sensormatic Electronics.

MDR 1/04

www.americandynamics.ne

RHOWCA CORNER MOUNT 8000-2692-10, REV. D
INSTALLATION GUIDE

2 of 2