Page 1
®
AMERICAN DIAGNOSTIC CORPORATION
®
IB p/n: 9352B-00 - rev 4
http://www.adctoday.com
email: info@adctoday.com
Fax: 1-631-273-9659
Voice: 1-631-273-9600
Hauppauge, NY 11788
55 Commerce Drive
®
Customer Service: 1-800-ADC-2670
©2011 ADC
NEW YORK • LONDON • TOKYO
AMERICAN DIAGNOSTIC CORPORATION
• Parts List
• Schematic
• Assembly Instructions
and follow the links
To Register Your Product, visit us at www.adctoday.com
752M
DIAGNOSTIX
™
HOW TO ASSEMBLE
1. With base on its side connect upright
outer pole to base using large (6mm)
allen bolt. Tighten with large (6mm)
allen key provided. Tighten hardware
as secu rely as p ossible. (Note: To
prevent loosening, hardware must be
tightened securely and periodically
checked). (Figure 1)
2. Slide stainless steel inner pole inside
outer sleeve with open end up.
(Figure 2)
3. Loosen (3mm) allen bolt on collar of
cuff storage basket with small (3mm)
allen key provided. Place cuff
storage basket on top of stainless
steel inner pole making sure the pole
goes completely inside collar and
tighten allen bolt with key. (Figure 3).
4. Attach manometer bracket to basket
using (6mm) allen bolt and washers
as shown. Tighten securely with
large (6mm) allen key. (Figure 4).
5. Adjust height of manometer by
loosening knob and raising or lowering
inner pole until gauge is at desired
height. Tighten knob by hand.
6. Connect coiled tubing to gauge inlet.
(Note: The coiled tubing may be difficult to connect, moisten with soapy
water if necessary). Refer to booklet
entitled DIAGNOSTIX
Pocket, Palm, Clock Type booklet
(9350N-00) for instructions on
operating the unit.
™
Aneroids
6mm 3mm
Included Tools
1
Allen Bolt
Connect outer pole (tube) to
base assembly. Note: Tighten
allen bolt securely by applying
as much force to allen key as
possible.
3
Insert pole into bottom of cuff
storage basket and tighten allen
bolt on side of the basket with
small allen key.
2
Slide inner pole inside outer pole.
Cuff storage
basket
4
Attach manometer bracket to
cuff storage basket.
Allen Bolt
Page 2
SCHEMATIC PARTS LIST
9C
9A
9C
9
8
9B
5
7
4
6
6A
2
3
1
3A
ROD & BASE ASSEMBLY FOR 752M
Ref # Item # Description
1 972-101 Center Pole Screw and Washer (1)
2 972-080 Base
3 972-106 Casters (5)
3A
972-106-1
4 972-107 Outer Pole
5 972-108 Knob
6 972-109 Spring
6A 972-107A Gasket
7 972-110 Inner Pole
8 972-111 Tightening Device
9 972-112 Basket
9A 752-113 Bracket
9B 752-114
9C 752-115
Single Caster
Manometer Mounting Hardware
Manometer Bracket Hardware
Loading...