American Diagnostic Corporation (ADC) 415FL Adtemp User Manual

AdtempTMIV 415 / 415FL

Digital Fever Thermometer

USE, CARE & MAINTENANCE

Intended Use:

A digital thermometer is a device used to measure the body temperature of a patient by means of a trans­ducer coupled with an electric signal amplification, conditioning, and display unit .

Safety Information:

• High, prolonged fever requires medical attention especially for young children. Please contact your
physician.

• Do not allow children to take their temperatures unattended.

• Read the enclosed instructions carefully to ensure accurate temperature readings. Temperature
readings are affected by many factors including exercise, drinking hot or cold beverages prior to
taking a reading, as well as technique.

• Do not allow children to walk or run during temperature taking. The probe could present a hazard.
Oral, underarm, and rectal temperatures vary by approximately 1°F (0.5°C).

• WARNING: Keep battery out of children’s reach. Swallowing battery could be harmful. Battery
should not be recharged or placed into extreme heat as it may explode.

• CAUTION:

Do not take an axillary temperature through patient’s clothing. Direct probe cover

to skin contact is required.

• CAUTION:

• CAUTION:

Biting the probe tip while taking a temperature may result in damage to the probe.
Do not autoclave. Please note the cleaning procedures described in this manual

How to take temperature:

1. Place a probe cover carefully over the tip (Figure 1). Select oral, underarm or rectal as your measure­ment site based on the individual requiring a temperature measurement.

2. Push the Multi-Function button located beside the display window. The thermometer will beep
and the display will read: “188.8 ° ”. This is a function check indicating the unit is working properly.
Next the thermometer will read “L°F”(or L°C).

F

M

3. The °F or °C symbol will flash when the unit is ready to measure
temperature. Please note that the “ ” indicates a low battery. See
instructions for replacing battery before measuring temperature. Do
not expect an accurate temperature reading if this low battery indicator is

Figure 1

present. An “ERR” message in the window indicates your unit is not functioning properly.

4. Depending on the measurement site, the unit will complete measurement in 10 (rectal), 15
(oral), or approximately 20 (axillary) seconds. The °F or °C symbol will stop flashing and
the unit will beep signaling completion.

5. Press the Multi-Function button for approximately 2 seconds. The last temperature will be
recalled. Record the temperature and time for reference. The reading will be automatically stored in
the memory.

6. Push the Multi-Function button to turn the unit off. This will prolong the battery life. If you
do not turn the unit off, it will shut off automatically in approximately 3 minutes.

Oral use: (for children 4 years and older)

1. Do not drink hot or cold fluids, exercise or perform other activities that will
raise or lower temperature readings when compared to your normal, average tempera­ture. The mouth shouldremain closed up to 5 minutes before attempting a reading.

2. Place the probe tip well under the tongue as indicated (Figure 2).

3. Instruct children not to bite down on the probe.

Figure 2

4. The peak temperature should be reached in approximately 15 seconds. Opening the mouth or im-

proper placement of the probe tip could result in a longer time for a reading.

Rectal use:

1. Commonly used for babies, young children or when it is difficult to take an oral or underarm tem­perature.

2. After placing the probe cover on the thermometer, lubricate with a water-soluble jelly or petroleum jelly .

3. Gently insert the probe tip no more than 3/4 inch or 2-3 cm into the rectum. Do not force the
tip into the rectum if resistance is encountered.

4. Dispose of the used probe cover and wash the thermometer as recommended.

5. The peak temperature should be reached in approximately 10 seconds.

Underarm (Axillary) use:

1. Wipe underarm with a dry towel.

2. Place probe tip in armpit and bring arm down against the body.

3. The probe should be pointing upward in the same direction as your body if possible.

4. The time required for an accurate underarm temperature may be 20 seconds or longer depending
on placement of the probe and closure of the arm against the body.

Changing Measurement Scale: From the OFF position, press the Multi-Function button to acti­vate the unit. Immediately after releasing the Multi-Function button, press the Multi-Function button
again and hold for 2 seconds. Press the Multi-Funtion button again to change from °F to °C or °C to
°F, and toggle back and forth. Release the Multi-Function button to set.

Memory Recall:

Press the Multi-Function button for approximately 5 seconds. The last temperature will be recalled
and displayed as long as the button is held down. When the button is released, the thermometer will
be in “ready-to-measure” mode and the recalled temperature will be erased.

Changing the battery:

When the “ ” appears in the lower right of the display, the battery is exhausted and needs replacing.
Make sure a battery of the same type is on hand and proceed as follows: Remove battery compartment lid.
Use a small pointed object, but not sharp metal. Withdraw the battery. Replace with a new button battery
(1.55v, LR41 or SR41) with the Cathode side (-) upward. Carefully replace the battery compartment lid se­curely. Properly dispose of the batteries, keeping them from small children and heat.

Standards:

Complies with EN 12470-3:2000 and ASTM E 1112-00

How to care for this product:

• Use of probe covers is recommended to help avoid spreading germs, and to keep the thermometer
clean. The thermometer should be cleaned after use even when probe covers are used.

• Clean the thermometer tip and probe only using isopropyl alcohol or soap and water.

• Store the unit in the protective case while not in use.

• Do not store or keep in direct sunlight, or in high temperatures.

• Keep battery away from children.

• Do not open the thermometer except to replace the battery.

• Do not drop the thermometer, as this may ruin the unit.

• The manufacturer recommends verifying the accuracy by an authorized laboratory every 2 years.

Specifications

Size: 6.06”L x 0.83”W x 0.47”H (154mm L x 21mm W x 12mm H)

Weight: 0.63 oz (18 grams) with battery

Display: LCD, Liquid Crystal Display

Battery: 1.55v (LR41) Alkaline

Battery Life: Estimated 4,000 uses (more than 200 hours of continuous use)

Measurement Time: Oral 15 Seconds / Rectal 10 Seconds / Axillary 20 Seconds

Measurement Range: 90.0°F to 109.9°F / 32.0°C to 43.9°C (±0.2°F/±0.1°C)

Operating Conditions: 50.0°F to 104.0°F / 10.0°C to 40.0°C

Storage Conditions: -4°F to 104.0°F / -20°C to 60.0°C

Relative Humidity: 15-95% Non-Condensing

Measurement Mode: Real measurement with peak-hold method

Audible Alarm: 1 beep at start-up. Continuous beep at measurement completion

Auto Turn Off: In approximately 3 minutes

Memory Feature: Stores last temperature taken

Parts and Assembly

Probe Tip

(415FL Model Only)

Flexible Probe Tip

Display Window

Battery Cover

Multi-Function Button

WARRANTY:This Thermometer is guaranteed for a period of 24 months from date of purchase. This warranty does

not cover batteries, or damage resulting from improper handling or use. Specific legal rights stipulated in your state
may guide this warranty. If you have a legitimate claim under this warranty, send item(s) postage paid to Service Center,
Attn: Repair Dept., 55 Commerce Dr., Hauppauge, NY 11788. Please include your name and address, phone no.,
proof of purchase, a brief note explaining the problem, your return address and $2.00 to cover shipping and han­dling.

ADC
55 Commerce Drive
Hauppauge, NY 11788
U.S.A.

ADC (UK) Ltd.
Unit 6, PO14 1TH
United Kingdom

IB p/n 93-415-00 rev 3 english

tel: [phone]

Inspected in the U.S.A.

Made in China

fax: [phone]

www.adctoday.com

email: [e-mail]