Amana R0163150 Instruction Sheet

Installation Instructions for

!

R0163150 (A) “P.C.” Circuit Board Assembly

It is important to READ this instruction sheet carefully before installing
“P.C.” Circuit Board Assembly.

Kit includes:

Quantity Part Number Description

1 D7773002 “P.C.” Circuit Board
1 R0158645 Instructions

WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power to unit before servicing, and
always reconnect ground wires after servicing.

Failure to follow these instructions may result in damage to the “P.C.” Circuit Board or improper operation
of the oven.

Verify the oven is unplugged before servicing. Wear a R0193576 static control wrist strap or equivalent whenever
handling the “P.C.” Circuit Board. Handle the circuit board only by the edges. Failure to handle “P.C.” Circuit Board
by the edges will damage the part.

All returned “P.C.” Circuit Boards must be placed in an Anti-Static Bag and carefully packaged in the replacement
part carton.

The service replacement “P.C.” Circuit Board in this assembly is Amana Part Number D7773002 circuit board.

1. Locate pins 9 and 10 on the “P.C.” Circuit Board.
A. Pins 9 and 10 are located behind the white keyboard connector on the top left side of the circuit board.
B. Locate jumper wires 2 PGM, NORM, and 13SEC. The jumper wires are located in a rectangular black

outlined box to the upper right of the white keyboard connector. The white keyboard connector is located on
the upper left side of the “P.C.” Circuit Board

2. Very carefully, cut or leave in the appropriate wire jumper strap on the “P.C.” Circuit Board as indicated by the
microwave oven model chart. The jumper wire straps must be cut in one place and bent so that the cut ends do
not make contact with any other conductor on the “P.C.” Circuit Board.

3. After the new “P.C.” Circuit Board is installed test run the microwave oven as per the instructions in the
appropriate service manual.

R0158645 Rev. 5 Page 1 of 2

05/18/01

Installation Instructions for
R0163150 (A) “P.C.” Circuit Board Assembly

Microwave Oven Model

Number

R310T, R311T OUT OUT IN IN IN
R320T, R321T, RW320T,

RW321T
R340P, R341P IN OUT IN IN IN
R350P, R351P INININININ
RS415T, CRS541T IN OUT IN IN IN
CRSW458P, RSW458P,

RS458P
MPS225-10 IN OUT IN IN IN
MW42 INOUTINININ
MW57, MW58 IN IN IN IN IN
WM714 INOUTINININ

Pin 9 Pin 10 2 PGM NORM 13SEC

INOUTINININ

IN IN IN IN IN

WM715 IN IN IN IN IN
R360P, RSB460P, R361P IN IN OUT IN IN
R370P, MW72, R371P IN IN IN OUT OUT
RS471P IN IN IN OUT OUT
MPS229-10 IN IN OUT IN IN

IN =

NOTE:

NOTE:

Leave Jumper Wire in “P.C.” Circuit Board.

If the model number of the microwave oven is not listed above, then cut or leave in the jumper wire(s) on the
new “P.C.” Circuit Board exactly like the old “P.C.” Circuit Board.

Old circuit board may not have 2 PGM, NORM, and 13SEC jumper wires.

OUT =

Cut jumper Wire out of “P.C.” Circuit Board.

Page 2 of 2 R0158645 Rev. 5
05/18/01  2001 Amana Appliances