Washer
PRODUCT MODEL NUMBERS
DRAIN SYSTEM OPTIONS
NTW5800T
Electrical: 120-volt, 60-Hz, AC-only,
15- or 20-amp. electrical supply. A time-delay fuse
or circuit breaker and separate circuit is
recommended.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10150593
09-15-08
RECESSED AREA AND CLOSET INSTALLATION
The dimensions shown are for the recommended spacing allowed (views 1 and 2), except
the closet door (view 3) ventilation opening. For closet installation, with a door, the minimum
ventilation openings in the top and bottom of the door are required (view 3). Louvered doors
with equivalent air ventilation openings in the top and bottom are acceptable.
Standpipe drain system - wall or floor (view 1 & 2)
The standpipe drain requires a minimum diameter standpipe of
2" (5 cm). The minimum carry-away capacity can be no less
than 17 gal. (64 L) per minute.
The top of the standpipe must be at least 39" (99 cm) high and
no higher than 96" (2.4 m) from the bottom of the washer.
Laundry tub drain system (view 3)
The laundry tub needs a minimum
20 gal. (76 L) capacity. The top of the
laundry tub must be at least 39"
(99 cm) above the floor and no higher
than 96" (2.4 m) from the bottom of the
washer.
Floor drain system (view 4)
The floor drain system requires a siphon
break that may be purchased separately.
The siphon break must be a minimum of
28" (71 cm) from the bottom of the
washer. Additional hoses might be
needed.
"
"
"
"
"
"
"
"
"
"
"
"
12 3
Front view Side view Closet door with vents
®
3
4