Amana NTW4500V, NTW4600V, NTW4800V, NTW5100T, NTW4500X Dimension Guide
...
Top-Loading Washer
27"
(0 mm)
PRODUCT MODEL NUMBERS
NTW4500V, NTW4600V, NTW4800V,
NTW5100T, NTW4500X, NTW4600X,
NTW4800X, NTW4880Y, NTW5100X
Electrical: A 120 volt, 60 Hz., AC only, 15- or 20-amp,
fused electrical supply is required. A time-delay fuse
or circuit breaker is recommended. It is recommended
that a separate circuit serving only this washer be
provided.
DRAIN SYSTEM
Drain system can be installed using a oor drain,
wall standpipe, oor standpipe, or laundry tub.
Select method you need.
Floor standpipe drain system
4.5"
(113 mm)
39"
(991 mm)
Minimum diameter for a standpipe drain: 2" (51 mm).
Minimum carry-away capacity: 17 gal. (64 L) per minute.
Some standpipes may require a Standpipe Adapter Kit and
additional drain hose that may be purchased separately.
See “Tools and Parts”. Top of standpipe must be at least
39" (991 mm) high; install no higher than 96" (2.4 m) from
bottom of washer. Installations higher than 96" (2.4 m)
require a sump pump system.
Wall standpipe drain system
OVERALL DIMENSIONS
Washer dimensions
1
25
(686 mm)
42"
(1067 mm)
Recessed area or closet installation
14" max.
(356 mm)
4"
(102 mm)
/2"
(648 mm)
19"
(483 mm)
Select proper location for your washer to
improve performance and minimize noise
and possible “washer walk”. Install your
washer in a basement, laundry room, closet,
or recessed area.
Dimensions show recommended spacing
allowed, except for closet door ventilation
openings which are minimum required.
Consider allowing more space for ease
of installation and servicing, spacing for
companion appliances and clearances
for walls, doors, and oor moldings. Add
spacing of 1" (25 mm) on all sides of washer
to reduce noise transfer. If a closet door or
louvered door is installed, top and bottom air
openings in door are required.
3"
(76 mm)
2
48 in.
(310 cm2)
2
24 in.
(155 cm2)
4.5"
(113 mm)
0"
1"
(25 mm)
3"
(76 mm)
Laundry tub drain system
See requirements for oor standpipe drain system.
Floor drain system
4.5"
(113 mm)
39"
(991 mm)
Minimum capacity: 20 gal. (76 L). Top of laundry tub must be at least 39" (991 mm) above
Floor drain system requires a Siphon Break Kit
and additional drain hose that may be purchased
separately. See “Tools and Parts”. Minimum siphon
oor; install no higher than 96" (2.4 m) from bottom of washer.
IMPORTANT: To avoid siphoning, no more than 4.5" (113 mm) of drain hose should
be inside standpipe or below the top of wash tub. Secure drain hose with removable tie
strap (A).
break: 28" (711 mm) from bottom of washer.
(Additional hoses might be needed.)
Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation
our products, we reserve the right to change materials and specications without notice. Instructions packed with product. Specications subject to change without notice.
Ref. W10200890C
06/2011
Loading...