39"
(99 c m )
28"
(71 c m )
Washer
PRODUCT MODEL NUMBERS
DRAIN SYSTEM OPTIONS
NTW5100T
NTW5400T
NTW4500V
NTW4600V
NTW4800V
Electrical: 120-volt, 60-Hz, AC-only,
15- or 20-amp. electrical supply. A time-delay fuse
or circuit breaker and separate circuit is
recommended.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10200331B
09-04-08
RECESSED AREA OR CLOSET INSTALLATION
If a closet door is installed, the minimum ventilation openings in the top and bottom of
the door are required (view 3). Louvered doors with equivalent air ventilation openings in
the top and bottom are acceptable.
Laundry tub drain system (view 3)
The laundry tub needs a minimum
20 gal. (76 L) capacity. The top of the
laundry tub must be at least 39 in.
(99 cm) above the floor and no higher
than 96 in. (244 cm) from the bottom
of the washer.
Floor drain system (view 4)
The floor drain system requires a siphon
break that may be purchased separately.
The siphon break must be a minimum of
28 in. (71 cm) from the bottom of the
washer. Additional hoses might be
needed.
"
"
"
"
"
"
"
"
"
"
"
"
12 3
Front view Side view Closet door with vents
®
12
34
Standpipe drain system - wall or floor (view 1 & 2)
The standpipe drain requires a minimum diameter standpipe of
2 in. (5 cm). The minimum carry-away capacity can be no less
than 17 gal. (64 L) per minute.
The top of the standpipe must be at least 39 in. (99 cm) high
and no higher than 96 in. (244 cm) from the bottom of the
washer.
IMPORTANT: To avoid siphoning, no more than 8" (20.3 cm) of
drain hose should be inside the standpipe.