Amana Ast2780ab, Ast2780ac, Ast2780as, Ast2780aw, Ast3080ab Owner's Manual
...
BUILT-IN TRIM KIT INSTALLATION INSTRUCTION
•
Trim Kit
•
Bottom Duct (1)
•
1" Screws
(4 Req'd 2 Extra)
•
Upper Duct (1)
•
1
/2"
Screws
(16 Req'd 2 Extra)
•
Anti-Tip Bracket (1)
•
Template (1)
•
Rear Duct (1)
•
Bottom Bracket (1)
(KEEP FOR FURTHER REFERENCE)
FOR TRIM-KIT MODELS - 27": AST2780AB, AST2780AW, AST2780AC, AST2780AS
- 30": AST3080AB, AST3080AW, AST3080AC, AST3080AS
• CAUTION: For personal safety, remove
house fuse or open circuit breaker before
beginning installation to avoid severe or
fatal shock injury.
• FOR USE WITH MICROWAVE OVEN
MODELS: ACM1580A/JMC9158AA
• FOR USE OVER ELECTRIC HEAT SOURCE
MODELS:
- 27": AOES2730, AOCS2740, ACO27SE1, JJW8127,
JJW8527, JJW9527
- 30": AOES3030, AOCS3040, JJW8130, JJW8530, JJW9530
1
PARTS INCLUDED
2
CUTOUT DIMENSIONS
27" 30"
1
" 17
Height 17
Width 25
Depth (min.) 23
Width
4
1
" 28
2
3
"23
4
Depth
1
"
4
1
"
2
3
"
4
Height
3" Min.
3
1. Disconnect the microwave oven before
proceeding with installation.
2. Remove any loose items inside the microwave
oven.
3. Fasten the bottom bracket to the bottom duct by
Rear
1
/2
"
screws.
Front
using four
1
/2
" screws (4)
P/No. 12506003
3828W5U0123
1
3
4. Install rear duct to the bottom duct with one
screw.
5. Remove the one existing screw from the right
side of the microwave oven.
6. Install bottom duct assembly with six screws as
shown. Fasten bottom duct to the right side of
cabinet with one existing screw.
1
/2
" screws (5)
Procedure Number 4
1
/2
5
"
1. On the cutout floor, mark hole centers for the
anti-tip brackets as shown using the supplied
template. Be sure to align the center line of
template to center line of cutout floor.
2. Drill two holes for anti-tip bracket.
7
/64
"
(use
drill or #35 drill)
3. Install anti-tip bracket onto cutout floor using
1
/2
"
two
screws.
DIMENSIONS:
13
/16
A =
B = 3
C = 20
"
"
1
/16
"
A
B
C
Center Line
Cutout Floor
Existing
1
/2" screws (2)
screw (1)
4
1. Remove the two existing screws from the back
side of the oven.
2. Peel off the backing of double sided tape.
Attach the upper duct on the microwave cabinet.
Press down firmly on duct. Fasten duct to back
side of cabinet with two existing screws as
shown.
Existing
screws (2)
1
/2
" Screws (2)
Anti-Tip Bracket
2
Loading...