Amana AEP200VA, AEP222VA Dimension Guide

20" (50.8 cm) Freestanding Electric Range

PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS

AEP222VA AEP200VA

Because Whirlpool Corporation policy includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.

CABINET OPENING DIMENSIONS

Ref. W10459122A

3/19/13

Cabinet opening dimensions shown are for:
25" (63.5 cm) countertop depth

24" (61.0 cm) base cabinet depth
36" (91.4 cm) countertop height

IMPORTANT: If installing a range hood or microwave
hood combination above the range, follow the range hood
or microwave hood combination installation instructions
for dimensional clearances above the cooktop surface.

NOTE: 24" (61.0 cm) minimum when bottom of wood or
metal cabinet is covered by not less than ¹⁄₄" (0.64 cm)
flame retardant millboard covered with not less than No.
28 MSG sheet steel, 0.015" (0.4 mm) stainless steel,

0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the

cooking platform and the bottom of an uncovered wood
or metal cabinet.

To eliminate the risk of burns or fire by reaching over
heated surface units, cabinet storage space located above
the surface units should be avoided. If cabinet storage is
to be provided, the risk can be reduced by installing a
range hood that projects horizontally a minimum of 5"
(12.7 cm) beyond the bottom of the cabinets.

Electrical Requirements:

To properly install your range, you must determine the type of
electrical connection you will be using and follow the
instructions provided for it here.

●

Range must be connected to the proper electrical voltage and
frequency as specified on the model/serial number rating plate.
The model/serial number rating plate is located under the front
left burner bowl. Refer to the figure in the “Location
Requirements” section.

●

This range is manufactured with the neutral terminal connected
to the cabinet. Use a 3-wire UL listed, 40- or 50-amp power
supply cord (pigtail) (see Range Rating chart below). If local
codes do not permit ground through the neutral, use a 4-wire
power supply cord rated at 250 volts, 40 or 50 amps and
investigated for use with ranges.

Range Rating* Specified Rating of

Power Supply Cord Kit
and Circuit Protection

120/240 Volts 120/208 Volts Amps

8.0 - 16.5 KW 6.0 - 12.5 KW 40 or 50**

16.6 - 22.5 KW 12.6 - 18.5 KW 50
*The NEC calculated load is less than the total connected load

listed on the model/serial rating plate.

**If connecting to a 50-amp circuit, use a 50-amp rated cord

with kit. For 50-amp rated cord kits, use kits that specify use
with a nominal 1³⁄₈" (34.93 mm) diameter connection opening.

●

A circuit breaker is recommended.

A

A

B

D

C

A. 36" (91.5 cm)
B. 19½" (49.5 cm)
C. 24½" (62.2 cm)
D. 42" (106.7 cm)

B

C

D

A

E

G

G

H

. 18" (45.7 cm) min. clearance

upper side cabinet to
countertop

B. 13" (33.0 cm) max. upper

cabinet depth

C. 20" (50.8 cm) min. cabinet

opening width

D. 20

" (51.1 cm) opening width

¹⁄₈

E. 5" (12.7 cm) min. countertop

space to side wall or other
combustible material

F. For minimum clearance to top

of cooktop, see NOTE.

G. Wall receptacle - 8" (20.3 cm)

from either cabinet,

H. 5½" (14.0 cm) max. from floor.

Locate 120/240-volt
receptacle in shaded area.

F