Titan II Split Top Drafting Tables
Tools required:
drill with
⁄
bit
Assembly Instructions
A
4
Frames, Left & Right
Angle Brackets
Tilt Mechanisms
Allen Wrench Key
ace
C
Crossbar
Crossbar
Crossbar
J
To Assemble
Base Frame
you have all the parts listed. Use care to
to differentiate left side frame from right, as
Attach rear crossbars (
and
C
A
Attach other side frame to opposite ends
Attach angle brackets (
Attach hinges (
for time being.
1
Attach
C
Attach
2
3
4
5
To A
ttach Tabletop to
Base Frame
6
fl oor to avoid scratches.
that come pre-attached to small board, as shown in
and small boards to create about 1/16" space between
them. A few quarters will work well.
with alignment.
with pre-drilled holes in small board. Attach using 3/4"
time being.
to the small board before tightening the angle bracket
The fi rst screws to tighten are the four that attach the
angle brackets to the
you must ensure that the wood frame is sitting fl ush on
the surface of the small board. Adjust the angle brackets
as necessary to ensure no space is left between these
the big board is still straight and square with the small
them. Use a measuring tool to ensure that the outside
and that front edge of the big board is parallel to the
front crossbar. Once everything is OK, tighten these
four angle bracket screws securely. Use care not to over
tighten and strip.
that the front wood frame is sitting fl ush on the board
tighten the four screws that attach the hinges to the
front oak crossbar
are in place between them. Use an awl or drill with 1/16" bit
to make starter holes. Use care not to drill all the way through
the tabletop. Attach using 3/4" Phillips screws. Tighten
Attach both tilt mechanisms (
J
as shown in diagram. Keep these screws slightly loose
for time being. Hint: Use elastic bands to keep tilt
25¢
FRONT
Align boards against wall
Attach front hinges to big board
J
7
8
9
10
11
12
13
14
15
16
17
18
©200
8
ALVIN & COMPANY, INC
• P.O. Box 188, Windsor, CT 06095-0722
www.alvinco.com
A8058 4/0
8
to ensure no space is left between these surfaces, and
then securely tighten the four screws that attach the tilt
through the tabletop. Attach using 3/4" Phillips
tighten and strip.
Attach drawer face to drawer front using 1" Phillips
and be sure that lock is on
the right side. Use care to ensure face is attached
Tighten screws securely.
Attach using 3/4" Phillips screws. Tighten securely.
This will require two people. Use care to keep drawer
Adjust tilt of tabletop to desired angle. The ratcheted tilt
top from the back edge until it clicks into the desired
And fi nally, just when you think you’re done, go back
and retighten all the screws and bolts on the entire
table to ensure that it remains strong, sturdy, and stable
for many years of use. You may want to fi ne-tune the
the drawer face screws from the inside and reposition
as necessary.
These caps are pressure fi t but you may want to apply a
fall out over time.
Thank you for purchasing an Alvin Drafting Table.
19
A
20
21
22
23
24
25
26
Loading...