Assembly Instructions for CE101
Children’s Adjustable-Height Easel
PARTS LIST
Key Qty. Description
A 2 Sets of Hinged Legs
B 2 Leg Cross Bars
C 2 Plastic Storage Trays
D 1 Green Chalkboard
E 1 White Dry Erase Board
F 1 Paper Roll Holder
G 4 2" Bolts
H81
I 16 Plastic Bolt Caps
J 2 Jumbo Paper Clips
K41
1
⁄2" Bolts
1
⁄4" Bolts
ASSEMBLY INSTRUCTIONS
1. Before assembly, check to see that you
have all parts shown on list.
2. Lay one of the hinged legs sets (A)
on the floor with the hinges facing up.
G
F
B
J
I
E
D
H
C
I
K
3. Open the legs and lay one of the leg
cross bars (B) with the notched side
facing you and the opening of the notch
pointing towards the hinges.
4. Align the holes and insert a 2" bolt (G).
Fasten with plastic bolt cap (I). Bolt
cap should be on the opposite side of leg
from the hinge.
5. Repeat for other set of legs.
6. Position both sets of legs in the upright
position with hinges facing one another.
7. Based on the height of the children to be
using the easel, determine whether the
upper set or the lower set of holes will be
used to mount the 2 boards.
8. Attach the green chalkboard (D) to one
1
side of the legs using 4 of the 1
⁄2" bolts
(H) and bolt caps (I).
A
9. Align one of the plastic storage trays (C) with the set of
holes just below the chalkboard (D) and attach to legs
1
4
⁄
using 1
10. Repeat steps 8 and 9 to attach the white board (E) and
storage tray (C) on the opposite side.
11. Place the paper roll holder (F) into the notches in each
of the leg cross bars (B).
" bolts (Part K) and caps (I).
Made in China
Alvin & Company, Inc. Bloomfield, CT Grand Prairie, TX
www.alvinco.com
Nov 2004
Loading...