K-STZ | K-STX
- Sunset
K-SSZ | K-SSX
INSTRUCTION MANUAL
07.10
KS015
Please keep this manual and product code number for future reference
and replacement parts ordering if necessary.
INSTALLATION INSTRUCTIONS FOR FRAMELESS BATHTUB AND SHOWER DOORS
Congratulations! You have made the r ight choice in buying this shower system.
We are convinced that you will be entirely sati
READ CAREFULLY AND COMPLETELY BEFORE PROCEEDING
ed with our pr oduct.
IT IS RECOMMENDED THATYOU WEAR SAFETY GLASSES AT ALL TIMES DURING INSTALLATION
INSTALLATION OVER CERAMIC TILE
If your shower door is to be installed over ceramic tile, tile should extend completely under both
wall jambs. Silicone should be used to seal the line where ceramic tile meets the base.
HOW TO CARE FOR YOUR DOOR
Never use scouring powder pads or sharp instruments on metal work or glass panels. An occasional
wiping down with a mild detergent diluted in water is all that is needed to keep the panels and
aluminum parts looking new.
Product speci cations are subject to change without notice.
PACKAGING CHECK LIST & HARDWARE
3
4
5
8
2
1
BOTTOM TRACK (1)
1
DOOR PANEL (2)
2
LEFT WALL JAMB (1)
3
TOP TRACK (1)
4
BUMPER (6)
5
RIGHT WALL JAMB (1)
6
GUIDE (3)
7
TOWEL BAR (2)
8
6
7
PAGE 1
REQUIRED TOOLS LIST
LEVEL
MEASURE TAPE
HAMMER
SILICON
SCREWDRIVERS
DRILL
PENCIL
PAGE 2
PACKAGING CHECK LIST & HARDWARE
5
B UTOI (6)
BUMPER (6)
7
LEFT SIDE GUIDE (1)
CENTER GUIDE (1)
RIGHT SIDE GUIDE (1)
9
TOWEL BAR BRACKET (4)
10
M4 X 20
MACHINED SCREW (3/4”)(8)
17
ANTI-JUMP PIN (4)
11
GLASS HOLDER (4) + CLEAR SLEEVE (4)
14
SCREW CAP (8)
15
M3.5 X 25
12
M4 X 16
SCREW 5/8” LG (14)
13
WALL PLUG (6)
16
M4 X 35
SCREW 1 3/8” LG (6)SCREW 1” LG (4)
1” MACHINED SCREW
FOR VERONA 10mm MODELS
PAGE 3
Step
INSTALL GLASS HOLDER (4)
1
INSTRUCTION MANUAL
WASHER (8)
CLEAR SLEEVE (4)
GLASS HOLDER (4)
DOOR PANEL (2)
1mm
NUT (4)
WHEEL (4)
17
INSTALL PIN ONLY HALF WAY (4)
9
TOWEL BAR (2)
Step
2
INSTALL TOWEL BAR (2)
9
10
8
9
15
PAGE 4
INSTRUCTION MANUAL
Step
8
WALL PLUG (6)
Step
4
Step
3
Step
5
Step
6
REPEAT ON BOTH SIDES
Step
BOTTOM TRACK (1) SILICONE UNDERNEATH
7
INTERIOR
SHOWER SIDE
SIDE VIEW
8A
8B
8C
Step
SCREW 1 3/8” LG (6) ATTACH BOTH WALL JAMBS
10
Step
9
INTERIOR
SHOWER SIDE
TOP VIEW
WALL JAMB (2) SILICONE ON BACKSIDE
REPEAT ON BOTH SIDES
PAGE 5
Step
11
FASTEN BUMPER (6) ONTO BOTH WALL JAMBS WITH 5/8” SCREW
Step
13
INSTRUCTION MANUAL
PLACE TOP RAIL ON THE WALLJAMBS.
INTERIOR
SHOWER SIDE
INTERIOR
SHOWER SIDE
Step
12
INTERIOR
SHOWER SIDE
SIDE VIEW
- FASTEN SIDE GUIDES (2) ONTO WALL JAMBS
AND BOTTOM TRACK WITH 5/8” SCREW
- PUT SCREW CAP.
INTERIOR
SHOWER SIDE
SIDE VIEW
Step
14
- FASTEN TOP TRACK ONTO WALL JAMBS WITH 5/8” SCREW.
- PUT SCREW CAP.
PAGE 6
Step
15
INSTRUCTION MANUAL
INSERT OUTER DOOR PANEL BY LIFTING UP & INTO TOP TRACK
PUSH PIN ALL THE WAY (17)
SIDE VIEW
INTERIOR
SHOWER SIDE
INTERIOR
SHOWER SIDE
SIDE VIEW SIDE VIEW
Step
16
INTÉRIEUR
DE LA DOUCHE
INTERIOR
SHOWER SIDE
SLIDE OUTER PANEL INTO SIDE GUIDE.
PAGE 7
Step
17
INSTRUCTION MANUAL
INSERT INNER DOOR PANEL BY LIFTING UP & INTO TOP TRACK
PUSH PIN ALL THE WAY (17)
INTERIOR
SHOWER SIDE
SIDE VIEW SIDE VIEW
SIDE VIEW
INTERIOR
SHOWER SIDE
Step
18
SHOWER SIDE
SLIDE INNER PANEL INTO SIDE GUIDE.
PAGE 8
Step
19
INSTRUCTION MANUAL
- PUT THE CENTER GUIDE IN THE MIDDLE OF THE BOTTOM TRACK
- FASTEN GUIDE WITH SCREW 3/8” LG (2) + SCREW CAP (2)
INTERIOR
SHOWER SIDE
INTERIOR
SHOWER SIDE
24
SIDE VIEW
Hours
PAGE 9
Loading...