Altronix RBR1224 Installation Manual

RBR1224 - Electronic Toggle/Ratchet Relay

LED

TRG --

NEG (-- )

C

NO

NC

NC

NO

C

POS (+)

TRG +

Specifications:

• 12VDC to 24VDC operation.

• Positive (+) or negative (-) ultra sensitive trigger
(3VDC to 24VDC @ 20mA minimum).

• DPDT contacts rated at
2 amp/120VAC/28VDC.

• Relay status LED.

• Remote LED status output.

• Snap track mountable (order part # ST3).

Board dimensions: 3"L x 2.5"W x 1"H

Applications:

• Use with PGM alarm control panel outputs.

• Electronically shunt-alarm zones,
door control or keypads.

• Interfaces with wireless receivers.

• Converts momentary to maintained contacts.

Installation Instructions:

1. Connect aux power to terminals marked [POS (+)] and [NEG (-)].

2. The relay will change state to latch ON or OFF by the application of a positive

momentary trigger voltage to the terminals marked [TRG +] and [POS (+)] or negative
momentary trigger voltage to terminals marked [TRG -] and [NEG (-)].

3. Relay status LED is lit when relay is energized. To use a remote LED. Connect negative

lead of remoted LED, to terminal marked [LED] connect positive lead of LED to [POS (+)].

Altronix is not responsible for any typographical errors. Product specifications are subject to change without notice.

140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: [phone]
website: www.altronix.com, e-mail: [e-mail], Lifetime Warranty, Made in U.S.A.
IIRBR1224 - Rev. 10803 G14J

MEMBER