Altronix POE60 Installation Guide

PoE60
Power Supply/Charger Board

Overview:

Altronix PoE60 provides 75W for NetWay Spectrum switches with 1Gb SFP ports. It converts 115VAC, 60Hz or 230VAC,
50Hz input into a 56VDC at 1.3A of continuous supply current (see specifications). It also features a optimized built-in
charger for Lithium Iron Phosphate type batteries.

Specifications:

Input:

• Universal Input 115VAC, 60Hz, 2.5A
or 230VAC, 50Hz, 1.3A.

Output:

• 56VDC/750W output.

• 1.3A continuous supply current.

• Filtered and electronically regulated output.

• Short circuit and thermal overload protection.

Installation Instructions:

PoE60 should be installed in accordance with The National Electrical Code and all applicable Local Regulations.

1. Mount PoE60 in the desired location/enclosure. Pay attention to correct positioning of the board, depending on
Altronix product being serviced. Mounting hardware included.

2. Set PoE60 to the proper AC input voltage via input voltage switch (Fig. 1, pg. 2).

3. Connect AC power from overcurrent protective device circuit breaker (20A @ 115VAC, 60Hz,
16A @ 230VAC, 50/60Hz) to the terminals marked [L, N] on power supply board (Fig. 1, pg. 2).
Use 14AWG or larger for all power connections (Battery, DC output, AC input).

Keep power-limited wiring separate from non power-limited wiring (115VAC/230VAC 50/60Hz Input,
Battery Wires). Minimum 0.25” spacing must be provided.
CAUTION: Do not touch exposed metal parts. Shut branch circuit power before installing or servicing equipment.
There are no user serviceable parts on unit. Refer installation and servicing to qualified service personnel.

4. Measure output voltage before connecting devices. This helps avoiding potential damage.

5. Connect devices to be powered to the terminals marked [– DC +].

6. When the use of stand-by batteries is desired, they must be Lithium Iron Phosphate (LiFePO4) type batteries.
Connect batteries to the terminals marked [– BAT +] (battery leads included).

7. When batteries are not used, a loss of AC will result in the loss of output voltage.

Battery Backup:

• Built-in charger for Lithium Iron Phosphate type batteries.

• Automatic switch over to stand-by battery when AC fails.

Features:

• Input voltage selection switch.

• Includes battery leads.

Board Dimensions (L x W x H approx.):

7” x 4” x 1.375” (177.8mm x 101.6mm x 34.9mm).

Terminal Identification:

Terminal Legend Function/Description

L, G, N Connect 115VAC/230VAC to these terminals: L to Hot, N to Neutral.
– DC + 56VDC @ 1.3A continuous supply current.
– BAT + Stand-by battery connections. Maximum charge rate 0.7A.

Fig. 1

LG N

--- DC +– BAT +

115/230VAC

Input

To LiFePO4

batteries

To Input of
the device

to be powered

Altronix is not responsible for any typographical errors. Product specifications are subject to change without notice.

140 58th Street, Brooklyn, New York 11220 USA | phone: [phone] | fax: [phone]
website: www.altronix.com | e-mail: [e-mail] | Lifetime Warranty | Made in U.S.A.
IIPoE60 - Rev. 12242018 G11S

MEMBER