Altronix LPD Installation Instructions

LPD - Low Power Disconnect Module

--- OUT +

SW2

+ INPUT ---

DEVICES

(Max. 8 amps)

DC
OUTPUT

--­+

--­+

SW1

Specifications:

• Input voltage: 12VDC or 24VDC max. 8 amps.

• Low voltage cutoff: 12VDC: 10.5 volts (+/--- 0.3 volts) 24VDC: 20 volts (+/--- 0.3 volts).

• Restore voltage threshold: 12VDC: 11.5 volts (+/--- 0.3 volts) 24VDC: 23 volts (+/---0.3 volts).

• Relay contact rating 8 amp max.
Board dimensions: 2.75"L x 2.2"W x 1"H

Operation:

Normal Condition: INPUT + connects via relay contact to OUTPUT +.
Low Voltage disconnect: INPUT + from OUTPUT + during low voltage cutoff.
Note: INPUT --- remains connected to OUTPUT --- at all times.

Voltage Selection Chart:

Output Voltage SW1 SW2
12VDC Open Closed
24VDC Closed Open

Installation Instructions:

1. Mount LPD in desired location/enclosure.

2. Set the LPD to desired operating voltage via SW1 & SW2 (see Voltage Selection Chart).

3. Connect output from power supply to terminals marked [+ INPUT --- ].

4. Connect devices to be powered to terminals marked [--- OUT +].

Altronix is not responsible for any typographical errors. Product specifications are subject to change without notice.

140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: [phone]
web site: www.altronix.com, e-mail: [e-mail], Lifetime Warranty, Made in U.S.A.
IILPD - Rev. 062408

MEMBER