Altronix DP4 Installation Guide

DP4

3.4375”

87.3mm

Power Distribution Module

Overview:

DP4 Power Distributing Module conveniently converts a single AC/DC input into four (4) individually fused outputs.

Specifications:

• Converts a single AC or DC input into four individually fused outputs.

• Handles up to 48VAC/VDC.

• Fuses rated at 3.5A (up to 5A fuses may be used).

• Surge suppression.

• Power ON/OFF switch.

• Power on green LED indicator.

• Includes Snap Track ST3 and clips.

• DIN Rail mount ready.

Board dimensions (W x L x H):

3.25” x 3” x 0.75” (82.55mm x 76.2mm x 19.5mm)

Installation Instructions:

The DP4 should be installed in accordance with The National Electrical Code and all applicable Local Regulations.

1. Mount the DP4 using included ST3 snap track and clips:

- Slide the board into the outermost slots on the ST3 (Fig. 2);

- Attach the clips to the back of ST3 using provided guides and slots;

- Mount the DP4 onto the DIN rail using the clips (Fig. 2).

2. Connect input power to the terminals marked [(AC) + DC - (AC)] (Fig. 1).

3. Measure polarity and output voltage before connecting devices. This helps avoiding potential damage.

4. Set power switch [SW1] to the OFF position.

5. Connect devices to be powered to the terminal pairs 1 to 4 marked [1A and 1B] to [4A and 4B] (Fig. 1).
Note: For DC voltage applications terminals marked A are Positive (+), and terminals marked B are Negative (-).

6. Set power switch [SW1] to the ON position.

Fig. 1 - DP4 Fig. 2 - ST3

1A 1B 2A 2B 3A 3B 4A 4B

LED

ON OFF

3.25”

82.55mm

(AC) + DC - (AC)

Input

power

0.625”

15.9mm

0.125”

3.2mm

0.875”

22.2mm

0.3125” (7.9mm)

2.875”

76.2mm

73mm

3”

Altronix is not responsible for any typographical errors.

140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: [phone]
web site: www.altronix.com, e-mail: [e-mail]. Lifetime Warranty, Made in U.S.A.
IIDP4 - Rev. 111101 G20P

MEMBER