Alto-Shaam 500-1D, 500-3D User Manual
500-1D
500-2D
500-3D
DRAWER WARMERS
DUE TO ONGOING PRODUCT DEVELOPMENT, SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
PRINTED IN U. S .A . #18 - 08/05
ITEM NO. _______________________
W164 N9221 Water Street • PO Box 450 • Menomonee Falls, Wisconsin 53052-0450 • U.S.A.
PHONE: 262.251.3800 FAX: 262.251.7067 800.329.8744 U. S. A. ONLY WEBSITE:
800.558.8744 U. S. A./CANADA 262.251.1907 INTERNATIONAL DIVISION www.alto-shaam.com
®
ANSI/NSF 4
ADDITIONAL FEATURES & OPTIONS
●
Built-in Trim kit
● Caster Stand Assembly
● Leg Stand Assembly
● Drawer Assembly with vents
■■ Specify on order
● Oversize drawer pan
● Perforated pan grid (to elevate product from bottom of drawer)
●
HALO HEAT . . . a controlled, uniform heat source that gently
surrounds foods for better appearance, taste, and longer holding life.
●
Product moisture is retained without adding water.
●
Holding temperature gauge monitors inside air temperature.
●
Dual wattage control on the one and two drawer 120V cabinets
for more precise control of hard-to-hold products.
— 500 watts for breads, rolls, biscuits
— 1000 watts for meat, potatoes, and vegetables
●
Extra large pans for additional capacity, or can be adapted to
accept standard full-size pans.
●
Canted thermostat knob and indicator light.
— Protects controls from damage
— User safety feature
●
ON/OFF adjustable thermostat.
●
Can be built into cabinets or counters. Built-in trim kits
are available.
●
Stackable design.
Exterior of 20 gauge non-magnetic stainless steel with one set of removable 16 gauge stainless steel drawer
rail supports per drawer. Each cabinet is controlled by one (1) ON/OFF adjustable thermostat with a range of
60° to 200°F (16° to 93°C) and includes one (1) holding temperature gauge to monitor inside air temperature.
Each drawer includes one (1) 12" x 20" x 6" (305mm x 508mm x 152mm) stainless steel pan. The drawer
assembly is easily adapted to accept an oversized pan that is 15" x 20" x 5" (381mm x 508mm x 127mm) for
greater capacity. Drawer warmers are designed with four (4) stacking projections, located on the top of each
cabinet, to allow stacking in any combination without the need of additional hardware. Individual drawer
warmers, or stacked combinations, can be mounted on a 5" (127mm) Caster Stand Assembly for mobility, or
a 6" (152mm) Leg Stand Assembly for stationary placement.
■■ MODEL 500-1D: one drawer warmer
■■ MODEL 500-2D: two drawer warmer
■■ MODEL 500-3D: three drawer warmer
ELECTRONIC CONTROL OPTION
■■
Solid state electronic control option simplifies temperature setting, has
a clear, easy-to-read LED display, and is adjustable in increments of 1 degree.
DUE TO ONGOING PRODUCT DEVELOPMENT, SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
PRINTED IN U. S .A .
DIMENSIONS: H x W x D
500-1D EXTERIOR:
11-3/4" x 24-3/8" x 24-5/8" (298mm x 618mm x 625mm)
500-2D EXTERIOR:
19" x 24-3/8" x 24-5/8" (482mm x 618mm x 625mm)
500-3D EXTERIOR:
26-1/8" x 24-3/8" x 24-5/8" (663mm x 618mm x 625mm)
Pan size: (
EACH DRAWER)
12" x 20" x 6" (305mm x 508mm x 152mm) GN 1/1
PRODUCT CAPACITY
20 lbs (9 kg) MAXIMUM • EACH DRAWER
(34 BAKED POTATOES, 50 DINNER ROLLS)
CLEARANCE REQUIREMENT (FOR VENTILATION)
Minimum: 3-inches (76mm) at the back, 2-inches (51mm)
at the top, and 1-inch (25mm) at both sides. On-site
venting for proper airflow must also be provided for
built-in counter installations.
INSTALLATION REQUIREMENTS
Drawer warmer must be installed level, and must not be
installed in any area where it may be affected by steam,
grease, dripping water, high temperatures, or any other
severely adverse conditions.
WEIGHT
500-1D 500-2D 500-3D
NET 80 lb (36 kg) 115 lb (52 kg) 150 lb (68 kg)
SHIP 90 lb (41 kg) 125 lb (57 kg) 165 lb (75 kg)
CRAT
E
16" X 27" X 30" 23" X 27" X 30" 30" X 27" X 30"
DIMENSIONS:
OPTIONS & ACCESSORIES
Built-in Trim Kit
■■ 500-1D 44224
■■ 500-2D 44226
■■ 500-2D FOR BU2-48, BU2-72 55532
■■ 500-2D FOR BU2-96 44231
■■ 500-3D 44228
■■ Caster Stand Assembly 15379
■■ Drawer Assembly with vents 55536
■■ Leg Stand Assembly 15380
■■ Pan, oversize, 15" x 20" x 5" (381 x 508 x 127 mm) PN-2123
■■ Perforated pan grid, 15" x 20" (381 x 508 mm) 1231
■■ Perforated pan grid, 12" x 20" (305 x 508 mm) 16642
ELECTRICAL
VOLTAGE PHASE CYCLE/HZ AMPS kW
120 1 60 LOW 4.0 0.5
HIGH 8.5 1.05
at 208 1 50/60 4.0 0.8
at 240 1 50/60 4.5 1.05
230 1 50/60 4.2 0.97
208-240
#18 - 08/05
500-1D
500-2D
500-3D
1-11/16" (42mm)
C
L
24-3/8" (618mm)
40-1/16" (1018mm)
22-13/16" (579mm)
11-3/4"
(298mm)
19" (482mm)
26-1/8" (663mm)
ELECTRICAL CONNECTION
ELECTRICAL CONNECTION
HI-LO Switch available only on 500 -1D and 500 -2D.
6-3/4" (171mm)
FOR LEG STAND OR CASTER STAND ASSEMBLY
24-5/8" (625mm)
HANDLE
500-1D, 500-2D, 500-3D
DRAWER WARMERS
W164 N9221 Water Street • PO Box 450 • Menomonee Falls, Wisconsin 53052-0450 • U.S.A.
PHONE: 262.251.3800 FAX: 262.251.7067 800.329.8744 U. S. A. ONLY WEBSITE:
800.558.8744 U. S. A./CANADA 262.251.1907 INTERNATIONAL DIVISION www.alto-shaam.com
®
(H x W x D)
NEMA 5-15P
15A, 125V PLUG
NEMA
6-15P
15A, 250V PLUG
FOR USA ONLY
CEE
7/7,
220-230V PLUG
(406 x 686 x 762 mm) (584 x 686 x 762 mm) (762x 686 x 762 mm)
DOMESTIC SHIPMENTS ONLY
Loading...