w
e
y
t
c
n
User's Manual
.
A
y
e
)
e
t
Product name : Immobilizer base station
Type : TWK1A026
It communicates with IC used both as Transponder and Passive RKE
through LF ANT(Z axis) of I-key H/U, and operates as ANT to exchange
communication data depending on community signal with BCM.
The immobilizer antenna communicates with the transponder in the hand unit
when the hand unit is brought close, and receives the code of the key. The
immobilizer is used by bringing the hand unit close as shown in figure.
HUND UNIT
The connector is arranged as shown in the figure belo
Immobilizer base station
NAME
CONNECTORPINLAYOUT
C/DC Suppl
Range of voltag
Consumption curren
Size
Operating voltag
Operating temperatur
range
Consumption curren
spe
Weight
Operation of frequency 125kHz
Under 1.0mA（Standby current）
MAX 200mA(@12.5V 25℃) at operatio
MAX 1.0mA(@12.5V 25℃) at standb
DC12V
DC6V～16V
W40.2xL70xH40.2（mm）
DC6～16V(Inner:DC 5V
-40~＋85 degree C
0.049kg
■CAUTION■
Pay attention to the following.
(The operation range might be changed by the environment. )
・Do not contact and bring metals close to the engine SW and the key.
・It may not be operated when using the equipment of the same
frequency band in the vicinity.
Please DO NOT the following. Engine is not started by failure of electronic
parts. (Product can not receive the signal correctly)
・Give a shock.
・Get it wet. If it got wet, wipe and dry up.
・Disassembly and modification
This device complies with Part 15 of FCC Rules and Industry Canada licenceexempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of
this device.
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Loading...