ALPS ALPINE WE1G0003 user manual

y

User's Manual

p

Product name : Straight Key FOB

Type : TWE1G0003

Since this device is always used with vehicle, it is not sold to general end users separately.
Therefore there is no user manual of this device by alone.
The following statements must be described on the user manual of the vehicle;

Transmitter is carried by the owner of the vehicle.
It performs transmission through RF antenna to tuner, vehicle performs
actions according to the signal.

Immobilizer Function

Unit Assy Immobi&Keyless communicates with the transponder in the
hand unit when the user inserts the hand unit in the key cylinder, and it
rotates

HUND UNIT UNIT ASSY IMMOBI

Ke

less Function

When the user pushes UNLOCK, LOCK, and Trunk button of HAND
UNIT, the RF electric wave is output, and TUNER　receives it, and an
open lock, the close lock of the door, and the signal of the trunk opening
are out

Operating temperature

Operation of frequency

ut.

Operation Voltage

Battery

range

Weight

UNLOCK Button
LOCK Button
Trunk Button

typ. 3.0V / max 3.3V

Lithium battery CR2032

-20~＋60　degree C Keyless

-40~+85 degree C Immobilizer

0.030kg

RF : 433.92MHz

LF: 125kHz

■CAUTION■

Pay attention to the following.

・It may not be operated when using the equipment of the same
frequency band in the vicinity.

Please DO NOT the following. Engine is not started by failure of
electronic parts. (Product can not receive the signal correctly)

・Give a shock.
・Get it wet. If it got wet, wipe and dry up.

・Disassembly and modification.

-CAUTION - Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type

-CAUTION - Do not exposed to excessive heat such as sunshine, fire or the like.
This device complies with Part 15 of FCC Rules and RSS-Gen of IC

Rules. Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation
of this device.

FCC WARNING

Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.

Procedure to check Model name, FCC ID and IC Number.

1. Remove the half cover with a flathead screwdriver.

2. Take out a PWB from the half cover.

3. FCC ID and IC Number are written on the button side of PWB.

half cover PWB

Procedure to check CE Marking.

1. Remove the half cover with a flathead screwdriver.

2. CE Marking is written on the inside of half cover.

half cover

Model name

FCC IDandIC

CEMarking