User Manual
Product name : Immobilizer base station
Type : I61M0
It communic ates with IC used both as Transponder and Pas sive RKE
through LF ANT(Z axis) of immobi-k ey, and operates as ANT to exchange
communicati on data depending on community s i gnal with BCM.
The immobilizer antenna communicates with the transponder in the immobi key when the it is inserted, and receives the code of t he key. The immobilizer
is used with key cylinder by inserting the immobi-key as shown in figure.
key cylinder
immobilizer anntena
immobi-key
The connector is arranged as shown in the figure below.
immobilizer anntena with
key cylinder
Terminal No. I/O
1I
2I
3 I/O
4I
56I
78I
AC/DC Supply
Range of voltage
Consumption current
Size
Operating voltage
Operating temperature
Terminal Name
GND
LEDG
SCI
SCL
-
VCC
-
LED
DC12V
DC5～16V
Under 0.7mA（Standby curr ent）
W69xL63xH54（mm）
DC5～16V(Inner:DC 5V)
-40~＋85 degree C
range
Consumption current
spec
MAX 150mA(@12V 25℃) at operation
MAX 0.7mA(@12V 25℃) at standby
Weight 0.043kg
Operation of frequency 125kHz
Since this device is always used with vehicle, it is not sold to general end users separately.
Therefore there is no user manual of this device by alone.
The following should be displayed in the user manual of the vehicle
This device complies with part 15 of the FCC Rules. Operation is subject t o t he
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must acc ept any interf erenc e rec eived, including interference
that may cause undesired operation.
FCC CAUTION
Changes or modifications not expressly approved by the part y respons ible f or
compliance could void the user’s aut horit y to operat e t he equipm ent .
Loading...