WV311602
Wall Lamp
TECHNICAL SUPPORT
1.833.MY ALORA(692.5672)
technicalsupport@aloralighting.co m
WARNINGS AND CAUTIONS
Important: ALWAYS be sure to
To avoid the risk of fire and/or shock fixture must be installed in compliance to national and local electrical and building codes.
If an existing fixture is being replaced take special notice of which wires were connected in the outlet box.
DO NOT SEPARATE ANY WIRES THAT MAY BE EXISITING IN THE JUNCTION BOX
DO NOT DAMAGE THE INSULATION OF JUNCTION BOX WIRES.
In Regular circumstances the BLACK wire will be “live”, WHITE will be “neutral” and GREEN or BARE COPPER will be “ground”. In older buildings it is always good practice to
reconfirm the polarity of the wiring.
NOTICE
• The important safeguards and instructions outlined in this sheet cannot cover
all possible conditions and situations that may occur. It must be understood
that caution and certain care factors must be followed. These instructions are
provided for your safety and we highly recommend that a licensed, trained
electrician install this unit.
• This fixture is designed to be mounted on a correctly installed standard round
or octagon box OR through a wiring box with a plaster frame. The box must be
securely mounted to the structure of the building. The crossbar and hardware
supplied should be used, directly mounting the fixture to the outlet box may
make it impossible to correctly align the fixture.
disconnect power before re-lamping or wiring the fixture. Read these instructions completely before starting installation.
1d. 1b.
3c.
3d.
1a.1c.
ASSEMBLY INSTRUCTIONS
Step 1
Remove the mounting plate (1c) from within the canopy (2a) by loosening
the two mounting screws provided (2b). Attach the mounting plate (1c) to
the junction box (1a) using two junction box screws (not provided) (1d).
Step 2
Connect fixture wires to junction box wires using the marrettes provided (1b)
(white to white “N”, black to black “L”, green to green “G”). Now secure the
canopy (2a) to the mounting plate (1c) using the two mounting screws
provided (2b).
Step 3
Place the glass shade (3d) over the fixture socket (3b) and secure by
threading the socket cover (3a) onto the socket (3b). Install recommended
lamp (not provided) (3c) (referred on the socket label for maximum wattage
and type) to fixture socket (3b). *If fixture has integrated LED (Light emitting
Diodes) lamp installation is not required*
You are now ready to enjoy your fixture.
3a.
3b.
2a. 2b.
3e.
P.
1.833.MY AL ORA (692.5672)
CANADA : 102 ∙19028 27TH Ave. - Surrey, BC V3Z 5T1
USA : 3035 E. Lone Mountain Rd - Las Vegas, NV, 89081
www.alor alighting.com
Loading...